1) Drag Characteristic Curve
阻力特性曲线
2) characteristic curve of resistance vs temperature
阻温特性曲线
3) magnetoresistive characteristic curve
磁阻特性曲线
4) impedance characteristics curve
阻抗特性曲线
1.
The impedance characteristics of the eddy current sensor are analyzed through the experiment,and the impedance characteristics curve of the sensor coil is acquired.
为了解决涡流传感器在测量汽车漆膜厚度时受被测基体材料的限制,通过实验对涡流传感器的阻抗特性进行了分析,得到了传感器线圈的阻抗特性曲线。
5) R-curve
阻力曲线
1.
In this paper, the strength-indentation load relation was analyzed, a new method is proposed to define the point in the K-curve at which the R-curve intersect the points form the locus of the R-curve.
结果发现这种改进的包络线法与常规的包络线法所测得的阻力曲线相吻合。
2.
The R-curve of SiC/BN laminated ceramics was evaluated using the indentation-strength method and compared with that of the monolithic SiC.
采用压痕法在SiC/BN层状陶瓷试样的表面引入不同尺寸的表面裂纹,利用三点弯曲测量含裂纹试样的极限断裂应力,研究了不同尺寸的表面裂纹对层状陶瓷断裂强度的影响;根据压痕载荷-强度实验结果,测定层状陶瓷的阻力曲线,并与单相SiC陶瓷对比。
3.
The crack-growth-resistance (R-curve ) behavior of Al 2O 3-SiCw and Al 2O 3-TiCp ceramic matrix composites was estimated by the indentation-strength method .
采用压痕 -弯曲强度法获得了Al2 O3 -SiCw和Al2 O3 -TiCp两种复合材料的阻力曲线 ,结果表明 ,与基体材料相比 ,两种材料均呈现出明显的上升阻力曲线行为。
6) resistance curve
阻力曲线
1.
Study of single specimen COD resistance curve test by unloading compliance method;
单试样COD阻力曲线试验技术
2.
The resistance curves were measured with the standard three point bending specimens and the double edge notched tension specimens at different mis-matching welded joint.
对管线用钢焊接接头,测试了标准三点弯曲试样、同种接头及不同匹配状态的双边裂纹拉伸试样的阻力曲线。
3.
Finally, determination of ductile fracture toughness of high ductile metal using stretched zone and determination of critical fracture toughness by the point of intersection of the crack resistance curves and realistic blunting line are suggested.
最后建议对于高延性材料采用SZ法 ,用实测钝化线与阻力曲线的交点所对应的延性断裂韧度值作其临界
补充资料：OC曲线(见抽样特性曲线)
OC曲线(见抽样特性曲线)
operating characteristic curve: see operating characteristic curve of sampling
O(:quxlanOC曲线(叮旧瓜叮唱Cha比‘teristic~抽样特性曲线。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条