1)  technic
轮换结果
2)  cycle
轮换
1.
The process of 4-step braiding is analyzed as an example to describe the application of the proposed method by expressing a braiding cycle as a product of disjoint cycles.
以“4步法”编织为例,应用置换理论分析了编织过程,将一个编织循环的置换结果表达成不相交的轮换的积的形式,建立了锭子运动规律与轮换表达形式的对应关系。
2.
By means of analyzing the equivalence relation of reversible gate logic network to permutation group,the reversible gate network cascade was converted into the cycle of symmetric group.
通过分析可逆门逻辑网络与置换群的等价关系,把可逆门网络级联转化为对称群的轮换问题。
3.
Let D be a selfcomplementary digraph with V(D)={1,2,…,n}, then the isomorphism between D and Dc can be represented as a permutation, σ, on the set V(D), σ(D)=Dc and it is assumed that all permutations are expressed as the product of disjoint cycles.
若把置换写成不相交轮换的乘积,且σ1和σ2有相同的轮换结构,就有{D|σ1(D)=Dc}={D|σ2(D)=Dc}。
3)  rotation
轮换
1.
The Application of Decision Tree in Food Rotation Business;
决策树方法在粮食轮换业务中的应用
2.
Different from the CPA rotation,the audit firm rotation is complete,but such rotation also brings about the high audit cost.
调查显示,与注册会计师轮换不同,注册会计师事务所轮换较为彻底,但事务所轮换也带来了较高的审计成本。
4)  alternation
轮换
1.
Triple integral and surface integral are first simplified through the alternation of integral variable and integral extent and then calculated in other ways so that the two kinds of integral calculation can be made simple.
探讨了轮换对称性在积分计算中的应用,利用积分变量与积分区域的轮换对称性先简化重积分及面积分,然后再采用其它方法来计算,使这两类复杂的积分计算变得简单。
5)  Cyclic Transformation
轮换
1.
: Generally,we often use the notions of transposition and cyclic transformation etc for definit-ing deferminant.
定义行列式时,一般要用到对换、置换等概念,置换群还是有限群的一个重要例子,本文对这些概念反轮换作一些探讨,得到了一些结果。
6)  alternate operataiotn
轮换操作
参考词条
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。