1) extremum difference
极值差
1.
Three rules of orderliness are discovered as follows: 1) the smaller the particle radius is, the more symmetrical the distribution of extremum difference is.
本文根据散射相位函数的定义,得到了偏振状态下单个粒子散射相位函数的表达式,并且通过研究发现以下规律:1)粒子半径越小,极值差随散射角越趋向于对称分布;2)散射角在0～0。
2) worse-case tolerance
极值公差
1.
Process tolerance is introduced in this paper after analysing their advantages and disadvantages of the worse-case tolerance and statistical tolerance.
公差常用表示方法有极值公差、统计公差。
3) Max-minimum and variance
极值方差
4) limit D-value
极限差值
1.
After pulley groove and wire rope worn and torn,if the practical D-value between the practical tested pulley groove diameter and the diameter of wire rope is less than the maximum limit D-value between pulley groove diameter and wire rope but larger than minimum limit D-value,ensure wire or less than minimum limit D-value,the wire rope can not work normally.
绳槽、钢丝绳磨损后 ,实际测得的绳槽直径与钢丝绳直径的实际差值 ,若小于绳槽直径与钢丝绳直径间的最大极限差值且大于最小极限差值 ,则确定钢丝绳能正常工作 ;如果实际差值大于最大极限差值或小于最小极限差值 ,可确定钢丝绳不能正常工作。
5) extreme value of deviation
偏差极值
6) extreme error
极值误差
补充资料：差差
1.犹参差。不齐貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条