说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 正弦插值
1)  sinc interpolation
正弦插值
1.
According to programming and simulation,the instauration results of sinc interpolation and linear interpolation for forming of some kinds of waves are compared and the RMS errors are computed and analyzed.
主要介绍了插值算法在数字存储示波器中的应用,通过编程和仿真比较了正弦插值和线性插值对几种不同波形的恢复结果,并计算和分析了相关的均方误差。
2)  sine interpolation algorithm
正弦插值算法
3)  sinusoidal interpolate basis
正弦插值基函数
1.
By using the sinusoidal interpolate basis and Daubechies discrete wavelet transform,the computing time is considerably reduced.
文中采用一种新的粗圆柱线天线快速精确计算模型 ,提出了所谓的“等长分段”方法 ,并使用了一种固定间隔电压源模型 ,大大提高了分析计算的精度 ;通过使用正弦插值基函数、引入Daubechies小波变换等 ,提高了分析计算的速度 。
4)  Sinc Interpolation
正弦内插
5)  quadrature sampling
正交插值
1.
Design of optimized algorithm of quadrature sampling and pulse compression;
正交插值与脉冲压缩的优化算法设计
2.
In pulse compression radar,quadrature sampling and pulse compression are the fore part of radar signal processing.
在脉压体制的雷达中,正交插值和脉冲压缩是雷达信号处理的前端,通用的分开处理的方法增加了系统结构的复杂性以及成本的提高。
6)  interpolated compensation
插值校正
1.
A new spectral interpolated compensation analysis method of periodic signals to compensate the spectral leakage caused by non-coherent sampling process is presented.
针对周期信号实际的非同步采样,提出一种频谱插值校正的分析法。
补充资料:Bessel插值公式


Bessel插值公式
Bessel interpolation formula

  十户,业匕生二匕二上业业二且+ ’7’/“(2陀)! 十户划卫二业三卫上塑二止逛卫业二业且, ‘J’/之(Zn+l)!与Gauss公式(l),(2)相比,Bessel插值公式具有某些优点;特别是,如果在区间的中点,即在点t=1/2上插值,则一切奇数阶差分的系数都等于零.如果把公式(3)右边最后一项略去,则所得到的多项式凡,十1(x0十th)虽然不是一个适当的插值多项式(它仅在Zn个结点xo一伍一 l)h,…,x。十从上等于f(x》,但是给出了比同次插值多项式更好的余项估计(见播值公式(interpolatlon扔皿ula)).例如,如果x二x0十th6(x。,xl),则使用关于结点x0一h,x。,x。十h,x。+Zh写出的最常用的多项式 。;‘x‘、+,、、_一、:,,、。,,},一工{、尸,,,业止卫. 一扒‘。’‘”‘一”/2’了’/’UZ}’了’‘’几得到的余项估计,比关于结点x。一h,x。,x。,h或x。,x。+h,x。+2h写出的插值多项式给出的估计几乎要好8倍.Bessel插值公式{肠份哭1 intellx面位用肠nll山反二e”“ItI℃Pn创扭”“o“”即中叩M扒a} 作为Gauss前位]插值公式与同阶的(j:,us、后“,J括值公式(见‘;auss插值公式(Gauss Interp‘)xa[;、)11 folmtlla))之和的半而得到的公式,旋于结点卜,丫。}h.丫。h,I。·“h,丫川,.丫川,l)/7的Gaus、前向插值公式为:八一点工二戈+111卜 (,,十,帆叮h)州·川、、少不一(l) 刃+口(l、l)叮启) (2,:+1)’关f一结点丫。二戈汁h即关J结点玩,h一、、,、Zh一丫。卜h‘、从曰”!泊,、月h的同阶的Causs后向插值公式为‘·:、‘、r一、·,::、了{卜、业示过· ‘,今、、三性二i上二_上二_塑_业工__妇匕__“__土 /l/2飞,卜, “,‘一”(2) 设 (声扮石‘) 一厂冷二一下一一Bessel插值公式取下列形式([l},口1) BZ十:(一‘.“h)(3) 、一、/:{,一井片/少沪 ’/一{2}’一2’
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条