1) tracking method
跟踪法
1.
In this paper,a new fuzzy clustering algorithm called tracking method is introduced,which ove.
文中采用了一种新的模糊聚类分析算法—跟踪法,该方法易实现编程,适用于处理大量数据,仿真实验证明分选结果较理想。
2.
Large single-phase load may cause load imbalance in future micro-network structure with high penetration,which is studied by three control strategies:tracking method,compensation method and SMVSC(Sliding Mode Variable Structure Control).
针对未来高渗透率的微网结构中,大量民用单相负荷的供电会导致微源本地不平衡问题,分别利用跟踪法、补偿法和滑模控制3种控制策略进行研究。
2) normal tracking
法向跟踪
1.
A new technology,which is called non-interference normal tracking for NC curve grinding was presented.
将快速点磨削技术引入到曲线磨削过程中,提出了曲线磨削中砂轮对工件轮廓实施法向跟踪磨削的新方法。
3) tracking algorithm
跟踪算法
1.
Project tracking algorithm based on attention mechanism
基于注意机制的投影跟踪算法
2.
Research on Infrared Image Enhancement and Target Tracking Algorithm
红外图像增强及目标跟踪算法研究
4) tracking algorithms
跟踪算法
1.
Tracking algorithms for coupling space light distorted by turbulence into single mode fiber;
大气湍流中空间光至单模光纤耦合的跟踪算法
2.
Have introduced a kind of tracking system design method of welding seam base on ultrasonic wave sensor, provide the total block diagram of the systematic hardware, software procedure module picture and tracking algorithms.
介绍了一种基于超声波传感器的焊缝跟踪系统的设计方法,给出了系统硬件总框图、软件程序模块图和跟踪算法。
3.
Combined with“4KTD-170 Four-Axes Servo Turntable System”project, the thesis finishes the development of Image Tracking System and the research of tracking algorithms.
本文结合“4KTD-170型四轴伺服转台系统”项目,完成了图像跟踪系统的研制并对跟踪算法进行了研究。
5) tracing algorithm
跟踪算法
1.
In this paper, a new tracing algorithm is presented for planar curve reconstruction based on the regular distribution property of the point set.
根据实际采样中离散点分布相对集中的特点,给出了一个用简单曲线拟合平面上的无序点集的跟踪算法。
6) tracking bug method
跟踪虫法
补充资料：法性属法为法性土
【法性属法为法性土】
谓真如法性之理，譬如虚空，遍一切处，乃是法身所证之体，即为所依之土，故名法性属法，为法性土。
谓真如法性之理，譬如虚空，遍一切处，乃是法身所证之体，即为所依之土，故名法性属法，为法性土。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条