说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 测试响应压缩
1)  test response compaction
测试响应压缩
1.
Based on test stimulus and test response, the test compression techniques can be classified to two categories; test stimulus compression and test response compaction.
测试数据分为测试激励和测试响应2种,测试压缩也对应分为测试激励压缩和测试响应压缩2个方面。
2.
The test compression techniques can be classified to two categories, that is, test stimulus compression and test response compaction.
根据测试数据性质的不同,测试压缩可分为测试激励压缩和测试响应压缩两个方面。
2)  Test response compactor
测试响应压缩器
3)  compression response
压缩响应
1.
The final thickness of a product after the vacuum infusion process (VIP), which is equal to the fiber volume fraction, depends in part on the compression responses of the preform because one of the mold faces is flexible in VIP.
在VIP(Vacuum Infusion Process)工艺中,零件的最终厚度也即是零件的纤维体积含量因单面模具和柔性真空袋的使用而部分地取决于预成型体的压缩响应。
4)  test response
测试响应
5)  Test compression
测试压缩
6)  geo-thermal response test
热响应测试
1.
The influence factors of ground heat exchanger system and existed questions in design and construction of ground source heat pump engineering were analyzed,and the principle and structure of self-developed movable geo-thermal response test apparatus were introduced.
分析了土壤热交换器系统的影响因素以及设计与施工中存在的问题,介绍了自主研制的移动式地源热响应测试装置原理与构成。
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条