说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 速率-传输方程
1)  Rate-propagation equations
速率-传输方程
1.
With ignoring the Excited State Absorption(ESA)and Ampli- fied Spontaneous Emission(ASE),the rate-propagation equations of the four-level system are simplified properly.
在忽略放大的自发辐射和激发态吸收的基础上,简化了四能级模型的速率-传输方程
2)  rate-propagation equation
速率-传输方程
1.
Using the overlapping integral method,the rate-propagation equations of the four level systems of EDWL at 980 nm are simplified properly.
研究了掺铒磷酸盐玻璃波导激光器的特性,利用重叠积分法将980 nm抽运的掺铒磷酸盐玻璃波导激光器四能级模型的速率-传输方程进行适当地的化简,同时考虑合作上转换效应和放大的自发辐射,利用数值模拟的方法,得到了掺铒玻璃波导激光器的输出功率与Er3+离子浓度、传输损耗、波导长度等参量之间的关系曲线。
3)  propagation-rate equations
传输-速率方程
1.
Channel Erbium-doped waveguide amplifiers(EDWA) are analyzed by solving propagation-rate equations.
通过求解传输-速率方程的方法对条形掺Er~(3+)波导放大器(EDWA)的特性进行了理论分析,包括特定折射率光波导中的信号光和泵浦光模场分布及EDWA的增益特性。
4)  rate equation and light propagation equation
速率方程和光传输方程
1.
The influence of concentration of rare-earth ions Er3+ and Yb3+ on gain and noise characteristics of Er3+/Yb3+ co-doped double-clad fiber amplifier is analyzed based on rate equation and light propagation equation.
基于速率方程和光传输方程,对双包层铒镱共掺光纤放大器进行了研究,数值模拟分析了Er3+浓度和Yb3+浓度的变化对光纤放大器增益和噪声系数的影响。
5)  rate and power propagation equations
速率方程和功率传输方程
1.
This paper analyzes the energy transfer process between the Er3+ and Tm3+ ions of Er-Tm co-doped tellurite fiber amplifiers pumped at 980 nm,sets up the rate and power propagation equations and obtains by simulation the law of variations of its amplification gain with the fiber length and pump power.
文章作者分析了铒铥共掺碲基质光纤放大器在980 nm泵浦下Er3+-Tm3+离子之间的能量转移过程,建立了速率方程和功率传输方程,并通过仿真得出了其放大增益随光纤长度和泵浦功率的变化规律。
6)  Power propagation equations
功率传输方程
补充资料:传输速率


传输速率
data transmitting rate

  ehuanshu sulo传输速率(datat~而tting毗)每秒传送的组成代码的二进制数的位数,即每秒若干位(bi『s)。传输速率与传输通道特征及传输介质有关。无线通道或远程有线通道,数据一般要经调制和解调,即将数字信号调制成适于通道传输的频率。在接收端解调后恢复为数字码,此时被调制信号相邻同值点之间最短标称时间间隔的倒数称做调制速率,单位为波特。 有线通信网络的传输介质性能各异,其传输速率也不相同,双绞线价格低廉,但其传输速率不高,约1兆位/秒左右;同轴电缆在带宽和抗干扰性方面较前者为好,其带宽可达ro兆”50兆赫,其中基带同轴电缆不用调制解调器,但传输速率一般不高于10兆位/秒,且传输距离不大于2千米,传输速率高于10兆位/秒则宜采用宽带同轴电缆。光纤是最理想的传输介质之一,传输速度高,抗干扰性好,获得了广泛应用。(何欣年)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条