说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 多路由表
1)  multiple routing tables
多路由表
2)  Multicast route table lookup
多播路由表查找
3)  multi-path routing
多路路由
1.
A load balancing multi-path routing in wireless sensor networks;
无线传感器网络中基于负载平衡的多路路由
2.
In order to improve resource utilization ratio, a multi-path routing algorithm is proposed, which probes and reserves resources in one of several parallel paths according to the status of network and the connection Q.
为提高网络的资源利用率,采用多路路由方法,在单一通路不能满足连接请求要求时,寻找多条能联合满足要求的一组虚拟不相交并路,并预留资源共同满足用户的服务质量要求。
3.
MPRP (Multi-path routing protocol) is an instance of ANRP and MPRP can meet the dynamic needs in computing service deployment.
本文在深入研究和分析主动网技术和传统路由协议之后,结合最新的面向服务的架构技术,提出了面向服务的主动网路由协议,并结合实际项目给出了一种具有主动路由协议特点的多路路由协议及网关的实现方法。
4)  multipath routing
多路路由
1.
A multipath routing based on region for mobile ad hoc networks(MANET) is proposed in this article.
提出了一种适用于移动自组网的基于区域的多路路由算法。
5)  route table
路由表
1.
This algorithm limited route between the same level nodes,reduced wireless inessential data exchange of the network and the route table divide into up and down routes tables,so that mitigated the request for the computation ability of especial equipments.
由于该算法限制同层节点之间的路由,所以减少了无线自组网与当前应用无关的信息交换量;同时将通常的路由表区分为上行和下行两个路由表,减少了路由运算所需的代码空间和时间,适应了特定的嵌入式系统对计算能力的限制。
2.
A relay topology was put forward based on the features of seismic acquisition system,and the key point of network protocol based on this architecture was also given,in which the generation of route table and dynamic IP address assign were discussed with emphasis.
针对分布式地震数据采集系统的特点,提出了一种接力式的网络拓扑结构,给出了基于该拓扑结构的网络协议设计要点,并着重讨论了其中IP的动态分配和路由表的建立方法。
3.
A relay topology is given based on the features of seismic acquisition system, and the key point of network protocol based on this architecture is given, in which the generation of route table and dynamic IP address allocation methodology are emphatically discussed.
将以太网技术应用于可控震源地震数据采集系统,以解决可控震源地震数据采集中的数据传输瓶颈,并针对可控震源地震数据采集系统的特点,提出了一种接力式的网络拓扑结构,给出了基于该拓扑结构的网络协议设计要点,着重讨论了其中IP的动态分配和路由表的建立方法。
6)  routing lookup
路由查表
1.
However traditional line card routing lookup and forwarding routing lookup mechanism will consume immense system resource and don t satisfy high speed routing lookup.
本文通过比较IPv4和IPv6线卡查表和转发查表,指出了传统查表机制在路由器支持IPv6的情况下的弊端,提出了一种路由查表机制的设计思想,并进行了系统仿真,其结果表明:该系统既节省系统资源,又提高了系统速度。
2.
This paper analyzes the difficulty of routing lookup and presents a survey of various kinds of lookup algorithms and compare s them in details.
查找路由表以给出下一跳地址是路由器中分组转发的核心步骤,因此快速的路由查表算法是实现高速分组转发的关键。
补充资料:多苯基多亚甲基多异氰酸酯
    多苯基多亚甲基多异氰酸酯,简称PAPI,或称粗MDI,浅黄色至褐色粘稠液体.有刺激性气味。相对密度(20℃/20 ℃)1.2,燃点218℃。PAPI实际上是由50%MDI与50%官能度大于2以上的多异氰酸酯组成的混合物。升温时能发生自聚作用。溶于氯苯、邻二氯苯、甲苯等。PAPI的活性低,蒸气压低,只是TDI的百分之一,故毒性很低。
    用于制造聚氨脂胶粘剂。也可直接加入橡胶胶粘剂中,改善橡胶与尼龙或聚酯线的粘接性能。贮存于阴凉、通风、干燥的库房内,远离火种、热源。严格防水、防潮,避免光照。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条