1) power contour
等功率圆
1.
this paper adopts the load-pull to present the tracking algorithm for the output power contour on the Smith char by using the microwave power automated test system.
结合Smith圆图,利用微波大功率自动调配器测试系统,采用负载牵引法,给出搜索等功率圆曲线的算法。
2) Constant power circle
晶体管等功率圆
3) power-circle
功率圆
1.
Based on the UHV(ultra high voltage) model and Thermal-Angle-Voltage limitation as a function of the power carried by the line,a power-circle has been proposed.
基于精确分析特高压线路输电能力的系统模型,结合特高压输电系统运行时的热极限、功角极限和电压约束,给出了用功率圆分析有功功率、无功功率与给定输电系统参数三者之间关系的方法。
4) power round diagram
功率圆图
1.
In view of the technical requirements of the LF in contract,the main electric technical data has been analysis through the methods of making the power round diagram for 140t LF equipment.
针对其中LF的合同条件,采用功率圆图分析的方法,对LF的技术参数进行确定与设计。
5) circle of equal probabitity
等概率圆
6) equal power
等功率
1.
Considered both output of the rolling mill and product quality,Netwton-Rapshon method is used to solve non-linear equations composed of each pass load according to equal power rolling tactics and to obtain the load and thickness for each pass.
在综合考虑轧机产量和产品质量的前提下,按等功率轧制策略利用Netwton-Rapshon法求解各道次负荷构成的非线性方程组,确定各道次负荷和待轧带钢的目标厚度,并开发了单机架六辊可逆冷轧机负荷分配计算程序。
2.
Here,the article shows a new way of studying the allocation of the rolling speed based on the principle of equal power.
本文以各道次等功率分配为原则,研究了轧制速度的分配方法,并编制了相应的计算机软件,为单机架可逆式冷轧机快速制定合理的轧制速度、提高带钢产量、降低轧制能耗提供了有力的参考依据。
补充资料：等圆
等圆
能够重合的两个圆叫做等圆.
说明：补充资料仅用于学习参考，请勿用于其它任何用途。