1) Ring failure
环路失效
2) Shutting failure
分路失效
3) resistors
开路失效
1.
Analysis of open circuit failure of chip resistors.;
厚膜片状电阻器开路失效分析
4) route break
路由失效
1.
Nodes remaining energy is considered in the new protocol,relying on node s remaining energy RREQ delay is adjusted,and the algorithm of avoiding route breaks is used in the new protocol,flooding broadcast is optimized by the restriction that the last time that nodes delivering data packet.
进行了节点的剩余能量的考虑,根据节点的剩余能量对RREQ延迟进行了调节,并采用了避免路由失效算法,利用节点最近一次传递过数据分组的时间作为约束条件对RREQ的洪泛广播进行了优化。
6) the failed link
失效路段
1.
An example was calculated,the upstream links are usually positively cor- related with the failed links and there is a time lag in the congestion propagating from one link to the next one under the incident.
本文利用 VISSIM 仿真软件,模拟路段失效的情况,研究得出失效路段与相关路段的影响关系。
补充资料：安培环路定律(见磁场强度)
安培环路定律(见磁场强度)
Ampere's circuital law
A rlpe{h口。)11L一dingILJ安培环路定律(Amp之re’5 CirC。ital law)见磁场强度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条