1) bit-reversed
位反序
2) in-situ reaction
原位反应
1.
Preparation of polyester/nano-ZnO composites by in-situ reaction;
原位反应合成聚酯/纳米氧化锌复合材料
2.
Fabrication of Al_2O_3-TiC/Al Composites by In-situ Reaction;
原位反应法制备Al_2O_3-TiC/Al复合材料
3.
In-situ reaction and phase composition design of monolithic refractories;
不定形耐火材料中的原位反应与相组成设计
3) in situ reaction
原位反应
1.
The room and elevated temperature mechanical properties,and fracture mechanism of the composites fabricated by in situ reaction method in the Al-TiO2-C system were studied.
讨论了Al-TiO2-C反应系原位反应合成铝基复合材料的常温和高温拉伸性能及其断裂机理。
2.
The TiN/Al2O3 composites were synthesized by in situ reaction using Al and TiO2 as starting materials,which were high energy milled and hot pressed.
结果表明:在球磨过程中粉料吸附并溶解了N2气,在后续热处理中原位反应形成了Ti2AlN相,当温度升高到一定程度时分解形成TiN,这有助于材料的致密化并使其力学性能提高。
3.
VCp/Fe composite was produced by in situ reaction,studied the influence of heat treatment on its structure and properties.
通过原位反应法制备了VCp/Fe复合材料,研究了热处理对其组织和性能的影响。
4) Coordination reaction
配位反应
1.
A novel technology about the integration of separation and coordination reaction of hesperidin with Cu2+ in ion-exchange chromatography(IEC) column was presented and performed in this paper.
提出并实现了橙皮苷分离及其与Cu2+配位反应一体化的新设想,并借助离子交换色谱、紫外可见光谱、X-射线衍射、傅立叶红外光谱和核磁共振等分析手段探讨其作用机理。
2.
The rate of the coordination reaction between divalent metal ions and murexide in a water-in-oil microemulsion was determined by spectrophotometric technique to study the transport of the metal ions entrapped in the organogel formed by cationic surfactant cetyltrimethylammoni.
以微乳液中二价金属离子与紫脲酸胺之间的配位反应为指示反应 ,采用分光光度技术 ,研究了金属离子在由阳离子表面活性剂十六烷基三甲基溴化胺构建的微乳凝胶中的传质问题 。
3.
Coordination reaction between H 2HAPP and metal ion Zn(Ⅱ) in CH 3OH CH 2Cl 2[ V (CH 3OH)∶ V (CH 2Cl 2)=1∶1] solvent was studied by UV Vis spectroscopic method, which indicated 1∶1 complexing between H 2HAPP and Zn(II) ion occurred easily in such a homogeneous sys.
适合 H2 HAPP与金属离子配位反应动力学等研究的均。
5) in situ
原位反应
6) in situ synthesis
原位反应
1.
Microstructure and mechanical properties of SiC_p/MoSi_2 composites prepared by in situ synthesis and hot-pressing;
原位反应热压SiC_p/MoSi_2复合材料的组织与性能
2.
In situ synthesis preparing methods of Metal Matrix Composites;
金属基复合材料的原位反应制备方法
3.
TiC_P/PH5-7Mo stainless steel composite was fabricated by the technique of in situ synthesis in high temperature melt of steel.
采用熔铸过程中的原位反应合成工艺方法,制备了TiCp/PH15-7Mo(0Cr15Ni7Mo2Al)钢基复合材料。
参考词条
补充资料：配位体反位效应
分子式：
CAS号：
性质：又称配位体对位效应。在过渡金属络合物中，配位体与中心金属以及诸配位体之间都是相互影响的。如配位体L与X在络合物中五相处于反应（即对位），当配位体X被另一基团取代或进行同位素交换反应时，处于X对位的配位体L对上述取代或同位素交换反应时，处于X对位的配位体L对上述取代同位素交换反应的速度有一定影响，这种影响称为配位体反应效应。如X能被更快速取代，是称配位体L具有强反应效应。
CAS号：
性质：又称配位体对位效应。在过渡金属络合物中，配位体与中心金属以及诸配位体之间都是相互影响的。如配位体L与X在络合物中五相处于反应（即对位），当配位体X被另一基团取代或进行同位素交换反应时，处于X对位的配位体L对上述取代或同位素交换反应时，处于X对位的配位体L对上述取代同位素交换反应的速度有一定影响，这种影响称为配位体反应效应。如X能被更快速取代，是称配位体L具有强反应效应。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。