1) quiescence collector current
静态集电极电流
1.
By adopting a simple and easy, we get the calculation formula of common-emitter and common-base configuration loop gain of oscillator circuit of three-point capacitance, hence work out an improved design of quiescence collector current and feedback.
采用一种简便方法,得到了共基和共射组态电容三点式振荡电路环路增益的近似计算公式,并由此找出了静态集电极电流和反馈系数的优化设计方案。
2) static anode current
静态阳极电流
3) quiescent current
静态电流
1.
Fault localization algorithm combining quiescent current and transient current;
一种将静态电流与动态电流相结合的集成电路故障定位算法
2.
The quiescent current of the amplifier is only 0.
设计了一种静态电流约为0。
3.
A low quiescent current LDO is presented in this thesis,which is designed and simulated based on SMIC 0.
18um Logic CMOS工艺设计和仿真的低静态电流低压差线性稳压器(LDO)电路结构。
4) IDDQ
静态电流
1.
Recently, a novel fault diagnosis technology including IDDQ and IDDT has developed rapidly.
基于电流的故障诊断方法包括静态电流诊断方法(IDDQ)和动态电流诊断方法(IDDT),是近期发展起来的新方法。
2.
Based on the technology of IDDQ and IDDT, this paper studies the method of fault diagnosis in circuit by applying theory of wavelet analysis and classification in pattern recognition.
本文以集成电路的故障检测和定位为主线,在采用静态电流检测(IDDQ)和动态电流检测(IDDT)技术的基础上,结合模式识别中的小波分析及分类决策理论,对电路的故障诊断进行了较为系统的研究。
5) static emitter current IE
静态发射极电流IE
6) collector current
集电极电流
1.
With this method in mind,the features of the collector current are analyzed when resonating circuit or resistor is loaded.
以此方式分析了负载为谐振回路及负载为纯电阻下集电极电流的特点。
2.
The PSpice model of a Darlington transistor is extracted and optimized in room temperature,some typical electrical characteristics of NPN Darlington pair based on Chip TIP120 are simulated,such as current gain(hFE),collector current vs.
达林顿晶体管的PSpice建模优化是在室温下完成的,一些典型的NPN达林顿对的电子特征是基于芯片TIP120仿真的,比如在不同的集电极-射极饱和电压状态下的电流增益(hFE),集电极电流vs,输入级电流,以及集电极-射极饱和电压和集电极电流之间的关系。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条