说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 屏蔽多导体传输线
1)  Shielded multiconductor transmission line
屏蔽多导体传输线
2)  shielded transmission line
屏蔽传输线
3)  shielded conductor
屏蔽导体,屏蔽导线
4)  shielded transmission line
屏蔽式传输线
5)  multi-conductor transmission line
多导体传输线
1.
The multi-conductor transmission line(MTL) theory was used in the analysis of the coupling between telecommunication cable and external field,the finite-difference time domain(FDTD) method was used to simulate the transient response.
多导体传输线理论分析外场与电缆间的耦合,时域有限差分法(FDTD)模拟通信电缆对外场的时域响应。
2.
Based on multi-conductor transmission line(MTL)theory, pulse propagation model of partial discharge in transformer winding is established.
基于多导体传输线理论建立放电脉冲信号在大型单相变压器绕组中的传输模型。
3.
This paper establishes the mode of corresponding equivalent circuit for transmission line coupling in homogeneous and inhomogeneous media based on the theory of multi-conductor transmission line,simulates and calculates the crosstalk among three conductor transmission lines on the PCB board using Matlab software.
运用多导体传输线理论为均匀及非均匀介质中的传输线耦合情况建立相应的等效电路模型,借助M atlab软件对PCB板上三导体传输线的线间串扰进行仿真计算。
6)  multiconductor transmission line
多导体传输线
1.
Based on Taylor and Agrawal models respectively,this paper presents analytical solution of response of multiconductor transmission line excited by uniformed plane waves.
基于空间电磁场激励下的Taylor和Agrawal传输线模型,分别推导了Taylor和Agrawal模型的均匀平面波激励下耦合多导体传输线终端响应的方程。
2.
In order to study the very fast transient overvoltage(VFTO)distribution in taper winding of pulse transformer(PT)under high-frequency voltage surge of steep front,a distributed line model of PT s secondary winding is built based on multiconductor transmission line(MTL)theory.
为了研究在陡波前、高重复频率的电压冲击下,脉冲变压器(PT)锥形绕组中的特快速暂态过电压(VFTO)分布特性,建立了基于多导体传输线(MTL)理论的PT二次绕组分布参数模型;利用锥形绕组结构上的特性,提出一种有限元法(FEM)和插值公式相结合的方法以快速计算锥形绕组的感应系数矩阵K;通过求解频域下的电报方程可得到绕组的对地电压分布以及匝间电压分布;进行了绕组暂态电压的测量,从实验结果可以看出电压分布的一定规律,并分析了造成计算与实验结果间误差的原因;结合实验提出一种改善电压分布的措施,对大功率PT二次绕组的绝缘设计有一定的参考意义。
补充资料:多线束均衡X线摄影


多线束均衡X线摄影


X线检查方法之一。以调整多个X线束曝光量的方法改进胸部细节对比的技术。MBER系统使用20个相邻的线束单元在水平方向组成扇形束,垂直方向扫描病人。每个线束单元均有各自的强度调整器和曝光检测器,后者配合电子反馈装置调节相应的调整器以使X线量不完全均匀化,使胸部均匀曝光,胸部影像记录在平面检测器上。当扫描纵隔或膈下时,调整器全部打开,以获得最大X线曝光量,扫描肺野时,仅打开约10%,这样获得的胸部影像能同时将肺野、肺纹理与纵隔及横膈遮盖区的解剖结构显示清楚,提高微小病灶的发现率。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条