1)  plug-In
Plug-In机制
2)  PL
PL
1.
The effects of Danbiqing granule on blood PL,WBC,AKP and morphologic changes in acute cholangitis rabbits;
胆必清颗粒对急性胆管炎家兔血PL、WBC、AKP及形态学改变的影响
2.
In this paper, TiO 2 nanoparticles pure and doped with varying content of Ce were prepared by a sol-gel process using Ti(OC 4H 9) 4 as raw material and characterized by XRD, TEM, BET, XPS and PL spectra.
采用sol gel法制备了纯的和掺杂不同量Ce的TiO2 纳米粒子 ,并利用XRD ,TEM ,BET ,XPS和PL光谱对样品进行表征 ,主要考察焙烧温度和含量对掺杂Ce的TiO2 纳米粒子性质以及光催化降解苯酚活性的影响 ,并探讨了Ce的掺杂对TiO2相变的作用机制以及PL光谱与光催化活性的关系 。
3.
The photoluminescence studies of the irradiated sample showed the intensity of PL was reduced and a blueshift were observed after irradiation.
8 MeV的电子对非故意掺杂的GaN材料进行了辐照,光致发光谱(PL谱)表明,辐照使PL谱的强度随电子注量依次降低,且主发光峰蓝移,在注量较高时,在3。
3)  PL)
PL)
4)  PL spectrum
PL谱
1.
Material structure was grown on(001)semi-induction InP substrate by molecular beam epitaxy(MBE) and measured by PL Spectrum.
衬底片选用(001)半绝缘InP单晶片,结构材料使用分子束外延(MBE)技术制备,并用PL谱对外延片进行测试,器件采用台面结构。
2.
It is found that the flow rate of O_2 influences the crystalline quality, surface morphology and PL spectrum of the as -grown ZnO thin films remarkably.
PL谱分析表明:随O_2气流量加大,带边峰明显增强,深能级峰明显减弱,ZnO薄膜光学质量提高。
5)  PL-TCM
PL-TCM
1.
This paper introduces firstly the technological process of Pickling Line and Tandem Cold Mill(PL-TCM) in Lysteel.
介绍了涟钢酸洗冷连轧联合机组(PL-TCM)采用四机架UCM轧机开发极薄规格产品(≤0。
6)  ε-PL
ε-PL
1.
The purification of ε-polylysine (ε-PL) by Ultrafiltration was studed.
采用超滤技术从ε-聚赖氨酸(ε-PL)粗品溶液中纯化ε-PL,研究了超滤过程中的操作压力、操作温度、超滤液的体积和料液初始浓度等因素对膜通量和粗品溶液中蛋白截留率及ε-PL透过率的影响;并确立了采用聚砜膜去除ε-PL粗品溶液中蛋白工艺的最佳参数,在此条件下,蛋白去除率达到86。
参考词条
补充资料:vent plug
分子式:
CAS号:

性质:用来封闭注液孔,同时允许气体逸出的蓄电池部件,又称气塞。塞上有小孔,沟通电池内部与大气,仅能防止外面异物落入电池,并不能防止电解液的溢出。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。