说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 无纸化考试程序
1)  examination procedure without test paper
无纸化考试程序
1.
In order to improve student’s capability of mastering and applying computer knowledge, a new way of test set by other teachers and an examination procedure without test paper are developed.
为提高学生掌握和应用计算机知识的能力,探索考教分离的新路子,开发了《计算机文化基础》课程无纸化考试程序无纸化考试程序通过近3 年对240 余个班级的考试,取得了教师与学生的共同认可。
2)  paperless examination
无纸化考试
1.
Study on paperless examinations on basic computer knowledge at medical colleges and universities;
高等医学院校计算机基础知识无纸化考试研究
2.
Research on paperless examination of Computer Application Foundation;
关于计算机应用基础无纸化考试的研究
3.
Briefly on paperless examination system;
浅谈新型无纸化考试系统
3)  non-paper examination
无纸化考试
1.
According to the fulfillment, present non-paper examination is analyzed by verifying the process dealing with the difficulty in the system, combined with the experts experience and item-response theories.
基于实践,分析了现有无纸化考试系统中试题难度的处理办法,结合专家经验和项目反应理论,给出了本课题所研发的考试系统中试题难度确定方法。
2.
An actualizing scheme of non-paper examination for multi-subject based on campus network is discussed.
本文研究了一种实现基于校园网跨学科教学无纸化考试的实施方案。
4)  Examination without paper
无纸化考试
5)  paperless test
无纸化考试
1.
according to the latest researches,this paper presents a new model of paperless test , and explores the conditions for the realization of paperless test in the digital net - based language lab .
提出了一种新型无纸化考试模式,并评述了现有教学设备在实现无纸化考试方面需作的改进。
2.
As the level of test standardization rises,online paperless test has found wider application.
随着考试标准化程度的提高,基于Internet网络环境下的无纸化考试,具有广泛的应用前景。
6)  No-paper examination
无纸化考试
1.
Research of Quantitative Analysis on No-Paper Examination Quality;
无纸化考试质量的量化分析研究
补充资料:金属化纸和金属化薄膜
      表面上蒸镀一层很薄 (0.1微米左右)的金属层的纸或薄膜。金属化纸曾应用于电缆、变压器作为屏蔽层,现多用于制造电容器。金属化纸和金属化薄膜的特点是具有自愈性,即当某处击穿时,短路电流使击穿部位周围的金属膜熔化并蒸发而又恢复绝缘性能,因此显著减少纸或薄膜中贯穿性导电疵点和弱点对击穿强度的影响,从而提高工作场强。低压纸介电容器如用铝箔极板(6~7微米),必须用2~3层纸或薄膜,若用金属化纸或金属化薄膜,只要1层即可,极板的厚度也由6~7微米减少到0.1微米左右,大大节省材料。直流或脉冲电容器用金属化纸时,为了提高绝缘电阻,可以在纸的单面或双面涂以约1微米厚的快干纤维漆,然后在真空中蒸镀0.1微米的金属膜。交流电容器用的金属化纸或金属化薄膜,为了不使介质损耗增大,不喷漆,而是在纸或薄膜表面上直接蒸镀金属膜。用于蒸镀金属膜的金属有锌、镉、镍和铝等,以锌最适合(沸点较低)。有些薄膜(例如聚酯薄膜)可以先在表面上蒸镀银层,然后再蒸镀锌层。
  
  金属化纸或金属化薄膜吸潮后,特别是在较高温度下容易被损伤腐蚀,在储存、加工过程中要采取适当的防潮措施。金属化纸一般不可用氯化物浸渍,以防止纸中析出的氢同氯化物浸渍剂析出的氯作用形成腐蚀性的氯化氢;但加了某些特殊的稳定剂后也可以用氯化物浸渍。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条