1) tangency process
相切处理
1.
This paper introduces an analyzing technique for determining aspheric particle images and gives a simple way of tangency process between two images.
从理论上给出了工业中有关类球形微粒的处理和分析方法,并提出了一种简便的图像相切处理方法。
2) chip disposal
切屑处理
1.
Four kinds of new indexable inserts with different groove parameters and geometric de-sign features are used to study the chip disposal of 45 middle carbon steel and ICr18Ni9Ti.
利用具有不同槽形参数和几何设计特点的四种新型可转位硬质合金刀片（ＣＮＭＧ１２０４０８－ＱＭ，ＣＮＭＧ１２０４０８，ＤＮＭＧ１５０６０８－１５，ＳＮＭＧ１２０４０８－Ｖ１）进行了４５号钢和奥氏体不锈钢ＩＣｒｌ８Ｎｉ９Ｔｉ的切屑处理对比研究。
3) slice process
切片处理
1.
A technique of acquiring the motion trajectory of robot directly is presented in the paper: firstly, three-dimensional model of work-piece is created in common CAD software and changed into STL format file, then a series of points with direction acquired through vector expand and slice process of the STL file, lastly robotic mo.
本文提出了一种由程序直接获取机器人运行轨迹的方法首先在普通CAD软件中对待喷涂零件三维建模并转换为STL文件,然后对STL文件的数据格式进行矢量扩展和切片处理,得到一系列带有方向的点系,最后按照一定规律排序形成机器人的运行轨迹。
4) treatment of kerf
切口处理
1.
It was indicated that the seeds with the treatment of kerf were the best,callus reduction rate could reach up to 90.
结果表明:最佳外植体为切口处理的种子,愈伤诱导率最高为90。
5) cutting treatment
切割处理
6) dual-phase treatment
双相处理
1.
Using two kinds of methods to raise the initial strength of 20 steel,one is dual-phase treatment after deformation and the other is dual-phase treatment after quenching.
采用形变后双相处理和淬火后双相处理两种方法提高 2 0钢的初始强度 ,并对两种方法得到的双相钢丝进行金相组织研究。
补充资料：相切相磋
1.相互研讨。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条