1) bubble
气孔形成
1.
Sapphire single crystal was grown by micro-pulling and shoulder at cooled center (SAP- MAC) technique and the air bubbles were observed as one of the main defects in the as-grown crystals.
本文探讨了影响气孔形成的工艺因素,从晶体生长动力学角度分析了气孔形成机理。
2) forming reason of porosity
气孔形成机理
3) pore-forming processes
气孔形成过程
1.
The porous ceramic tile,which main crystals is the quartz and mullite,has been developed by using ceramic polished waste as the main raw materials,and the effects of ceramic polished waste on pore-forming processes of the porous ceramic tile have been analyzed in this paper.
本文以陶瓷抛光废料为主要原料,研制了以石英和莫来石为主晶相的多孔陶瓷轻质砖,采用XRD、显微镜分析了陶瓷抛光砖废料对其气孔形成过程的影响,探讨了影响其气孔形成的主要因素。
4) pore
气孔
1.
Study on pore problem of GAP low-oxygen propellant during curing process;
GAP贫氧推进剂固化气孔问题研究
2.
Analysis and Solution of Pore Defect of WD615 Cylinder Head;
WD615气缸盖气孔缺陷的分析与解决
3.
Process Study on Reducing Pore in Production of Solid Composite Propellant;
复合固体推进剂生产中减少气孔的工艺研究
5) porosity
气孔
1.
Weld porosity shortcomings reasons for the formation and Preventive measures;
焊缝气孔缺陷的形成原因及防治措施
2.
Prevention and mechanical analysis of porosity formation in pulsed CO_2 laser welding of 30CrMnSiA;
脉冲CO_2激光焊接30CrMnSiA气孔控制及机理分析
3.
Laser welding of high nitrogen steel 1Cr22Mn16N Ⅰ. Influence of shielding gas composition and heat input on N-content and porosity of weld metal;
1Cr22Mn16N高氮钢激光焊接 I.焊接保护气体组成和热输入对焊缝氮含量及气孔性的影响
6) Gas Hole
气孔
1.
Influence of Vacuum Dead-point on Gas Hole for Die Casting;
抽真空截止点的位置对压铸件气孔的影响
2.
Formation cause and prevention of gas holes in stainless steel wirerope clamper castings produced by investment casting;
不锈钢钢丝绳夹座熔模铸造气孔的产生与防止
3.
Formation and Prevention of the Gas Holes in Investment Cast Steel Casting;
熔模铸钢件气孔的产生与防止
参考词条
补充资料：表面气孔
surfaceblowhole：位于铸件表面的气孔。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。