1) adding of fiber
掺加纤维
2) optimum fiber content
最佳纤维掺加量
1.
By deviation analysis methods and integrated balance methods,the main factors affecting the high temperature performamce and moisture performance of the polyester fiber-reinforced asphalt concrete are analyzed and then the optimum fiber content and the optimum asphalt content are determined.
利用基于马歇尔试验方法的多因素正交试验,运用极差分析法和综合平衡法比较了各个指标对聚酯纤维加强沥青混凝土的高温稳定性和水稳定性的影响,从而确定聚酯纤维加强沥青混凝土的最佳纤维掺加量及最佳沥青用量。
3) Steel Fiber Additional Range
钢纤维掺加范围
4) fiber content
纤维掺量
1.
The variation between fiber content and compressive strength,splitting strength were analyzed.
为了研究纤维掺量对沥青混凝土强度的影响,选用5种纤维掺量沥青混凝土的马歇尔试件和圆柱体试件,在MTS810材料试验机上进行劈裂试验和单轴压缩试验,分析了劈裂试验结果和抗压强度随纤维掺量变化的规律。
2.
When the base strength grade is in the range of C30~C50,and thread steel fiber content is 0~1.
5%掺量范围内,对抗压强度的增强作用明显;当基体强度等级达到C60,纤维掺量在0。
3.
The viscoelastic performance was simulated by using four-unit five-parameter model,its parameters were obtained from the data of the test,and a four-unit five-parameter viscoelastic constitutive model with fiber content was set up.
根据粘弹性力学理论,采用"四单元五参数"模型(修正的Bugers模型)模拟纤维沥青混凝土的粘弹性能,其参数值由试验数据的数值拟合获得,提出了计入纤维掺量的"四单元五参数"粘弹性本构模型。
5) fibers content
纤维掺量
1.
It was found that the error is sensitive to temperature and fibers content.
Weng在Eshelby-Mori-Tanaka理论基础上提出的纤维增强复合材料的等效模量公式,计算了具有不同纤维掺量的纤维沥青混凝土在不同温度状态下的等效劲度模量,对计算结果与劈裂试验结果进行了比较和误差分析。
6) silica-doped TiO2 fiber
掺硅TiO_2纤维
补充资料：掺掺
1.女手纤美貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条