1) global absolute error bound
全局绝对误差界
1.
In this paper,the estimation of the error bound for the generalized linear complementarity problem over a closed polyhedral cone(GLCP) was consider,and GLCP was equivalently converted into an affine variational inequalities problem over a closed polyhedral cone(AVIP) under suitable conditions,and then a global absolute error bound for GLCP establish as well.
在适当条件下将凸多面锥上的广义线性互补问题等价地转化为凸多面锥上的变分不等式问题,利用变分不等式的误差界,建立了凸多面锥上的广义线性互补问题的全局绝对误差界。
2) absolute error bound
绝对误差界
3) global error bound
全局误差界
1.
A class of merit functions for the second-order cone complementarity problems and a global error bound;
二阶锥互补问题的一类效益函数与全局误差界
2.
in trust region method,we present a global error bound for the distance between a feasible solution and the optimal solution under the condition that the gradient vector of the objective function is strongly monotone.
本文利用信赖域方法中的几个特征量(由预测下降量给出的价值函数与信赖域半径等),在目标函数的梯度向量是强单调的条件下,为约束最优化问题的可行解与最优解之间的距离提供了一个全局误差界。
4) absolute error
绝对误差
1.
By comparison with the results of ideal Henon sequence mixed with noise,the improved Farmer algorithm is able to increase the precision of noise attenuation and reduce the absolute error between itself and ideal Henon sequ.
通过对混有噪声的Henon序列进行仿真实验,仿真结果显示,改进后的Farm er算法能够提高噪声衰减的精度,降低与理想Henon序列的绝对误差。
2.
According to original laser measure error and error analysis transfer expressions,calculations about absolute errors and relative errors of the measuring deformation of wing were performed.
以激光器的原始测距误差为出发点,依据误差传递公式,分析了测量机翼变形量的绝对误差和相对误差,并给出了计算仿真结果和相应的图形。
3.
It may measure the frequency and phase of the signal which begin from 10 Hz to 20 kHz,absolute error isn′t more than 1°.
可以对10 Hz～2 0 k Hz频率范围的信号进行频率、相位等参数的精确测量,测相绝对误差不大于1°;采用数码管显示被测信号的频率、相位差。
5) Global error
全局误差
1.
Due to the differently inherent correlation of the test samples,the key of the algorithm takes both factors of local and global error into consideration comprehensively,and takes values of the global error as dependent variable of function of changing step length,then changes learning rate dynamically.
由于测试样本内在关联度的差异,算法的关键是综合考虑局部误差和全局误差2个因素,并且以全局误差值作为步长改变函数的因变量,进而动态地改变学习率,而且这种学习率的改变是有条件的改变。
6) AGT
绝对全局
1.
)It is to use AGT to communicate in the nodes and ALT as the local time to calculate and so on.
然后指出使用绝对全局时钟进行节点之间的通信,而用绝对本地时钟作为处理机本地的时钟来进行计算以及其它各种操作。
补充资料：绝对误差
分子式：
CAS号：
性质：通常简称为误差。是测量值与真值之差。用来表征测定结果的准确度。当不知道真值时，就不能确定测量值的误差，通常以国际上公认的量值(如标准原子量值)、国家标准物质的保证值或纯净物质的组分含量当作真值使用，以衡量某一分析方法和测量结果的准确度。
CAS号：
性质：通常简称为误差。是测量值与真值之差。用来表征测定结果的准确度。当不知道真值时，就不能确定测量值的误差，通常以国际上公认的量值(如标准原子量值)、国家标准物质的保证值或纯净物质的组分含量当作真值使用，以衡量某一分析方法和测量结果的准确度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条