1) thermotolerant fungus
耐热真菌
1.
A thermotolerant fungus was isolated from the soil sample collected near the factory which produces soybean oil by using a selective medium.
利用选择性培养基从发霉的豆粕、豆油工厂周围环境中取样并分离纯化获得一株产热稳定性α-半乳糖苷酶耐热真菌,通过形态学和分子生物学鉴定方法初步鉴定该菌株为分枝犁头霉。
2) drug resistance fungal
耐药真菌
3) halophilic fungi
耐盐真菌
1.
Study on halophilic fungi population of Yipinglang;
一平浪盐矿耐盐真菌的种群调查
4) Thermophilic acidophilic bacteria
耐酸耐热菌
1.
Thermophilic acidophilic bacteria have a strong adverse effect on the flavor of drinks made from apple juice concentrate,which leads to more and more stringent requirements for these bacteria in apple juice drinking countries.
耐酸耐热菌存在于浓缩苹果清汁中,严重影响其加工产品饮料的风味。
2.
But the apple veberage that comes from apple juice concentrate has off flavor because of thermopHilic acidopHilic bacteria and its growth.
但因浓缩苹果清汁配制的苹果汁饮料中耐酸耐热菌生长繁殖和代谢的产物直接影响产品风味,已成为浓缩苹果清汁出口的难题。
5) Alicyclobacillus
耐热菌
1.
Research on stability of ozone in water and it’s non-thermal sterilizing effect on Alicyclobacillus;
臭氧水稳定性及对耐热菌冷杀菌的研究
2.
Solution properties of ozone in water and its non-thermal sterilizing effect on Alicyclobacillus;
臭氧溶解特性及对耐热菌非热杀菌的研究
6) Alicyclobacillus acidoterrestris
耐热菌
1.
Sdudy on the preparation methods of templates in detection of Alicyclobacillus acidoterrestris by PCR;
PCR法检测耐热菌模板制备方法研究
2.
Optimization and Establishment of Quantitatively Competitive PCR System for the Detection of Alicyclobacillus acidoterrestris;
耐热菌的竞争定量PCR检测方法优化与建立
3.
concentration of Taq DNA polymerase and Mg 2+ , annealing temperature, recycle temperature/time, number of cycles in rapid detection of Alicyclobacillus acidoterrestris by PCR technology was presented in this paper.
以耐热菌为研究对象 ,对PCR法快速检测耐热菌的扩增条件 :Taq酶浓度、Mg2 +浓度、退火温度、循环温度 /时间、循环次数 5个方面进行了优化。
补充资料：奥氏体耐热钢
分子式：
CAS号：
性质：显微组织为奥氏体的一类耐热钢。高温强度比珠光体和马氏体耐热钢要高，工作温度可达700℃左右。以18Cr-8Ni为基础的奥氏体不锈钢，高温强度也很优良，所以也作耐热钢使用。这些钢主要是为超临界压锅炉的过热器管而开发的，使用温度高于650℃。典型的奥氏体耐热钢有：1Cr18Ni9Ti钢，4Cr14Ni1W2Mo钢，SUH31钢，SUH309钢，310钢和SUH661钢。
CAS号：
性质：显微组织为奥氏体的一类耐热钢。高温强度比珠光体和马氏体耐热钢要高，工作温度可达700℃左右。以18Cr-8Ni为基础的奥氏体不锈钢，高温强度也很优良，所以也作耐热钢使用。这些钢主要是为超临界压锅炉的过热器管而开发的，使用温度高于650℃。典型的奥氏体耐热钢有：1Cr18Ni9Ti钢，4Cr14Ni1W2Mo钢，SUH31钢，SUH309钢，310钢和SUH661钢。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条