1) respiratory energy dissipation transpiratory energy
呼吸能量损耗
2) respiration consumption
呼吸损耗
1.
The degree of reduction was increased with the increase of C:N ratio and the tendency of reduction was in agreement with the weight loss of substrate, lignocellulose degradation, and the respiration consumption.
菇产量以C/N比50—60:1最高,但菇产量的高低与基物失重、粗纤维减少、呼吸损耗多少没有关系,而与培养料的C/N比值却有明显的曲线关系。
3) big breathing loss
大呼吸损耗
1.
This article introduced the principle of the big breathing loss in the underground tank of oil depots, suggested to replace the non - closure oil - unloading process with panseal oil - unloading process, which could decrease breathing loss and avoid the influence to surrounding environment.
介绍了加油站埋地储罐收油时存在大呼吸损耗的情况,并根据瓦廖夫斯基、契尔尼金蒸发损耗公式,用全密闭卸油工艺对无密闭卸油工艺改造了接卸油系统,使用结果表明,全密闭卸油工艺既可降低大呼吸损耗,又可减少对周围环境的影响,值得在加油站推广。
4) breathing loss
小呼吸损耗
1.
There are many reasons which cause breathing loss, however, the most important factors are the physical quantity and their variations.
影响储油罐小呼吸损耗的因素是多方面的,但主要因素是油罐内各种物理量及其变化对小呼吸损耗的影响最为重要。
5) energy consumption
能量损耗
1.
Analysis of energy consumption in blank holding of single-action deep-drawing hydraulic press;
单动拉深液压机压边能量损耗分析
2.
By analysing hydraulic system of motorized wheel dump truck, the model of energy consumption is set up.
通过对电动轮自卸车液压系统的分析,建立系统能量损耗模型,并进行计算仿真,可以得出这种系统的能量损耗主要是单向阀的泄漏损失,单向阀的泄漏流量是影响能量损耗的主要参数,而与蓄能器的容积无关,并且得出系统保压时间为60秒。
3.
Analyzed the minimum theory and the theories of DC electric power drag system ,the mathematics model of the energy consumption is built, the optimization answer of controls parameter used by armature electric current is resolved according to the minimum theory, and the feasibility of the minimum energy consumption is analyzed .
在分析了极小值原理和直流电力拖动系统的基础上 ,建立了与能量损耗有关的数学模型 ,利用极小值原理解出了以电枢电流为控制量的最优解 ,并对最小能量损耗控制的可行性进行了分
6) energy loss
能量损耗
1.
The Analysis and Management System for Energy Loss of Whole Power Network;
全网能量损耗分析与管理系统
2.
While the circular tunnel is filled with coal, the energy loss is related with conductivity of coal.
进而证明了圆形隧道充满煤介质时能量损耗与其电导率有关 ,隧道中悬浮的粉尘在电磁场作用下发生瑞利散射 ,散射功率的一部分构成损耗 ,能量损耗与粉尘分布密度成正比 。
3.
The energy losses, friction stresses, back stresses and shape parameters of hysteresis loops were measured from the hysteresi.
记录了各循环周次的应力、应力-应变滞后回线,根据回线的面积和形状计算了循环形变中的能量损耗、摩擦应力、反馈应力及形状参量。
补充资料：能量损耗
分子式：
CAS号：
性质：变形周期中损失的能量与材料体积之比。亦称之为单位阻尼能。高分子材料具有黏弹性，发生变形时不是完全的弹性变形，而伴随着发生塑性变形。在发生塑性变形时，由于分子间或晶面间的滑移，摩擦生热等耗去了能量，因此不能使原加的能量完全以形变能贮存，并在恢复过程中释放。失去的那部分能量就属于能量损耗。正确了解这一点，就可以根据不同用途来进行选材，也对新材料的研究起指导作用。
CAS号：
性质：变形周期中损失的能量与材料体积之比。亦称之为单位阻尼能。高分子材料具有黏弹性，发生变形时不是完全的弹性变形，而伴随着发生塑性变形。在发生塑性变形时，由于分子间或晶面间的滑移，摩擦生热等耗去了能量，因此不能使原加的能量完全以形变能贮存，并在恢复过程中释放。失去的那部分能量就属于能量损耗。正确了解这一点，就可以根据不同用途来进行选材，也对新材料的研究起指导作用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条