1) hydraulic surface loading
表面水力负荷
1.
Tested under these operating conditions,the field test results showed that under the hydraulic surface loading 1 m3/(m2·d),flooding time/drying time=1∶3、earthworm load 12.
结果表明,在表面水力负荷1m3/(m2。
2) surface loading
表面负荷
1.
The influence of air-water ratio,HRT(hydraulic retention time),media-filling rate for biological contact oxidation tank and dosage of flocculating agent,surface loading for flotation tank on pollutants removal was studied.
开展了生物接触氧化/气浮工艺处理微污染源水的中试研究(规模为20 m3/h),考察了生物接触氧化池的气水比、水力停留时间、悬浮生物填料填充率和气浮池混凝剂投加量、表面负荷对污染物去除效果的影响。
3) surface load
表面负荷
1.
It is believed that in designing the secondary sedimentation tanks for extended aeration systems, in addition to the calculation on the basis of surface load, the factor of solid load also should be taken into consideration.
就活性污泥法在不同系统中二沉池的设计参数如何取值进行了探讨 ,认为在延时曝气系统的二沉池设计中除了根据表面负荷计算之外 ,还应考虑固体负荷这一因
2.
In sorting out the experimental data of coagulating sedimentation,manual calculation and curving are usually used to find out the relationship among the removal rate C,the surface load u0 and the residence time t.
在凝聚性沉淀试验的数据整理中,要找出去除率C、表面负荷u0和停留时间t之间的关系,通常用人工计算和手工画曲线的方法。
4) hydraulic loading
水力负荷
1.
Study on influence of hydraulic loading for running of ANAMMOX reactor;
水力负荷对厌氧氨氧化反应器运行影响的研究
2.
Design of hydraulic loading cycle for constructed rapid infiltration wastewater treating systems;
人工快渗污水处理系统水力负荷周期的设计
3.
Effect of hydraulic loading and HRT on nitrogen removal of foam board floating island;
水力负荷及水力停留时间对泡板型浮岛脱氮效果的影响
5) hydraulic loading rate
水力负荷
1.
The influence of hydraulic loading rate on filter performance was investigated by adjusting hydraulic loadings, and using zeolite, cinder and polythene pipes as the control media.
通过改变水力负荷,研究了水力负荷对滤器性能的影响,并比较了以沸石、煤渣和塑料短管为填料的试验结果。
2.
The results showed that the IVCW effectively removed total suspended solids(85%),chemical oxygen demand(50%),five-day biochemical oxygen demand(44%),total ammonia(53%),nitrite(83%) and nitrate(54%) from the aquaculture wastewater at a hydraulic loading rate(HLR) of 420mm/d.
结果表明,在420 mm/d的水力负荷下,湿地可有效地去除循环水中的总悬浮物(去除率85%)、CODCr(去除率50%)、BOD5(去除率44%)、总氨氮(去除率53%)、亚硝酸盐(去除率83%)和硝酸盐(去除率54%),能够满足养殖用水的要求,整个试验期间系统实现了零污水排放。
3.
8% of TP at the hydraulic loading rate(HLR) of 3.
采用水耕植物过滤法(hydroponic bio-filter method,HBFM)净化富营养化地表水的试验表明,在水力负荷为3。
6) hydraulic load
水力负荷
1.
Effect of hydraulic load on efficiency of enhanced biological nitrogen removal in subsurface infiltration system
地下渗滤生物强化系统的建立及水力负荷对系统脱氮效果的影响
2.
The influence of hydraulic load and air/water ratio on the pollutant removal efficiency was investigated.
采用以沸石为填料的侧向流曝气生物滤池(LBAF)处理生活污水,考察了水力负荷和气水比对其除污效果的影响。
3.
Comprehensively considering the purification effect and wastewater treatment capacity,the hydraulic load should be controlled at 0.
采用复合垂直流渗滤系统处理城镇生活污水,试验结果表明,经过1个月左右的启动阶段,系统出水水质基本达到稳定;复合垂直流渗滤系统能承受较高的有机负荷,采用沉淀作为其前处理工艺的效果较为理想;综合考虑净化效果和处理能力,复合垂直流渗滤系统的水力负荷宜控制在0。
补充资料：水力负荷
分子式：
CAS号：
性质：投加于某一给定水处理设施的水或废水量。它是水处理构筑物的一项设计和运行参数。一般以单位时间内的水量容积或单位时间、单位表面积(水池)内的水量容积表示。
CAS号：
性质：投加于某一给定水处理设施的水或废水量。它是水处理构筑物的一项设计和运行参数。一般以单位时间内的水量容积或单位时间、单位表面积(水池)内的水量容积表示。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条