1) carbon-based packed bed
碳基填充床
1.
Considering the feasibility of hydrogen-enriching pre-reduction in two-step smelting reduction process,the effects of gas parameters and shaft heights on hydrogen-enriching reforming of gas in a imaginary carbon-based packed bed were simulated.
考虑到二步法熔融还原炼铁工艺中富氢预还原的可行性,模拟了在某一假想碳基填充床内待改质气体参数和碳基填充床高度对改质过程的影响。
2.
Considering the feasibility of hydrogen-enriching pre-reduction in COREX smelting reduction process, and in order to make the effective utilization of gas high-temperature physical heat,the effect of gas flux and tem- perature on hydrogen-enriching reforming of gas in an imaginary carbon-based packed bed was simulated.
考虑到COREX熔融还原炼铁工艺中高温煤气物理余热的有效利用和富氢预还原的可行性,模拟了在某一假想碳基填充床内待改质气流通量和气体温度对改质过程的影响。
3.
Considering the feasibility of hydrogen-enriching pre-reduction in two-step smelting reduction process,the effects of gas parameters and shaft heights on hydrogen-enriching reforming of gas in a imaginary carbon-based packed bed were simulated.
考虑到二步法熔融还原炼铁工艺中富氢预还原的可行性,模拟了在某一假想碳基填充床内待改质气体参数和碳基填充床高度对改质过程的影响。
2) carbon particle bed`
碳粒填充床
3) packed bed
填充床
1.
Interaction between flow of gas mixture and gas-solid reaction in a packed bed;
填充床中气体流动与气固反应的相互作用
2.
Numerical Study of Smoldering Combustion Propagation and Characteristics of Ignition-Extinguishing and Transition to Flaming in a Horizantal Packed Bed;
填充床内阴燃传播的数值模拟及阴燃着火—熄火、向明火转捩特性分析
3.
Numerical simulation study of forward smoldering propagation of cellulosic material in a horizontally packed bed
水平填充床中纤维质燃料正向阴燃数值模拟研究
4) packed-bed
填充床
1.
Decoloration of methylene blue by ceramisrt packed-bed in pulsed high voltage electric field;
高压电场中陶粒填充床对亚甲基兰的脱色效能
2.
Crystal packed-bed crystallizer is designed and used to separate and purify para-dichlorobenzene from a mixture of para- and ortho- dichlorobenzene.
用设计的晶体填充床结晶器,从对二氯苯、邻二氯苯的混合物系中分离提纯对二氯苯,考察了晶体床层高度、回流比、进料浓度、搅拌转速等操作因素对结晶器分离性能的影响,并分析了结晶器的操作过程。
3.
The influences of the thickness of the packed-bed,filling mass and flow rate on the effectiveness of removing oxygen were studied.
阐述了三维电极电化学去除溶解氧的基本原理和实验方法 ,并就三维电极填充床的厚度、填料、流速等对除氧效果影响进行了研
5) filling bed
填充床
1.
The factors of affecting the sugar extracted from cane shred in filling bed was studied in this paper.
本文研究填充床蔗料中糖抽提的影响因素。
6) Rotating packed bed (RPB)
旋转填充床
1.
Modified aluminum hydroxid was prepared by carbonation of sodium aluminate in Rotating Packed Bed (RPB) coupled with hydrolysis.
利用旋转填充床碳分-水热耦合法制备改性氢氧化铝。
2.
Sulfur dioxide gad was absorbed when sodium hydroxide wan used absorption liquid in a rotating packed bed (RPB).
本文分析了目前脱硫烟气脱硫现状和存在的问题,特别指出了双碱法用于塔板等脱硫设备存在脱硫率低,装置占地面积大等缺点,从而提出了将双碱法用于旋转填充床的脱硫方法。
补充资料：填充离子交换树脂的电渗析器、电渗析填充床等
分子式：
CAS号：
性质：又称填充离子交换树脂的电渗析器、电渗析填充床等。这是将离子交换树脂充填入电渗析器隔室中，将电渗析与离子交换树脂结合一起的一种脱盐方法。这种装置可以提高脱盐室的电导，并能有效地防止极化沉淀以制备高纯水。但其结构比较复杂，拆装不便。其工作原理为：将H+，OH-型阳、阴树脂予混后填充入电渗析器脱盐室。在直流电场作用下，阴、阳树脂与溶液中的阴、阳离子进行交换。之后，由于电解再生，树脂分别又转为H+，OH-型，解吸的阴、阳离子分别通过阴、阳膜进入浓缩隔室。
CAS号：
性质：又称填充离子交换树脂的电渗析器、电渗析填充床等。这是将离子交换树脂充填入电渗析器隔室中，将电渗析与离子交换树脂结合一起的一种脱盐方法。这种装置可以提高脱盐室的电导，并能有效地防止极化沉淀以制备高纯水。但其结构比较复杂，拆装不便。其工作原理为：将H+，OH-型阳、阴树脂予混后填充入电渗析器脱盐室。在直流电场作用下，阴、阳树脂与溶液中的阴、阳离子进行交换。之后，由于电解再生，树脂分别又转为H+，OH-型，解吸的阴、阳离子分别通过阴、阳膜进入浓缩隔室。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条