1) punching straight thread joint
镦粗直螺纹接头
1.
The workmanship and operation flow of the punching straight thread joint is introduced, including the process in a factory.
介绍了镦粗直螺纹接头的工艺和流程以及工厂化加工过程。
2) straight thread splices with upset rebar ends
镦粗直螺纹钢筋接头
3) the upsetting straight thread bar
镦粗直螺纹连接
1.
The construction technology of the upsetting straight thread bars connection;
钢筋镦粗直螺纹连接施工技术
4) heading straight thread
镦粗直螺纹
5) parallel thread rebar splicing with cold upsetting end
钢筋镦粗直螺纹连接
6) thick straight steel bar
钢筋镦粗直螺纹
补充资料:自动冷镦机、多工位螺栓自动冷镦机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB9166-88、JB/T3053-91 | ||||||
1、冲头夹持器模孔中心线对夹持器后支承面的垂直度(mm) 在100长度上 | 0.008 | 0.01 | 0.015 | >0.015 | |||
2、凹模座模孔中心线对凹模后座支承面的垂直度(mm) 在100长度上 | 0.008 | 0.01 | 0.015 | >0.015 | |||
3、冲头夹持器模孔中心线对滑块行程的平行度(mm) 在100行程上 | 0.016 | 0.02 | 0.02 | >0.02 | |||
4、滑块行程对机身上与凹模座贴合的垂直面的垂直度(mm) 在100行程上 | 0.016 | 0.02 | 0.02 | >0.02 | |||
5、工件头部对工件杆部中心线的偏移量(mm) | <0.20 | 0.20~0.25 | 0.25~0.30 | >0.30 | |||
(二)生产率(件/分) | |||||||
20mm | >80 | 70 | 65 | <65 | |||
30mm | >60 | 50 | 45 | <45 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条