说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 高频暂态分量
1)  transient high-frequency component
高频暂态分量
1.
A high pass digit filter is designed to extract transient high-frequency component of zero sequence current, according to significant transient component of zero sequence current of resonant earthed system with single-phase-to-ground fault.
谐振接地系统单相接地故障零序电流暂态量显著,设计一个高通数字滤波器,提取出零序电流的高频暂态分量
2)  high frequency transient
高频暂态
3)  transient state component
暂态分量
4)  transient component
暂态分量
1.
Study on fault transient component of EHV long distance transmission lines
超高压长距离输电线路故障暂态分量的研究
2.
It also discusses their influence respectively and analyses the character of fault transient component at both sides of fault point in different fault types.
利用Ⅱ型网络等值长距离输电线路,推导了频域下考虑线路分布电容,电源侧分布电容,串补电容,母线电容及并联电抗器时线路故障暂态分量的表达式,讨论了它们各自对故障暂态分量的影响,同时分析了在不同故障类型情况下,故障点两侧暂态分量的特征。
3.
Using wavelet analysis to realize single-phase grounding protection is easy to produce misjudgement and missed sanction and the method using magnitude and direction of transient component to realize single-phase protection needs calculate frequency and phase of transient component accurately.
采用小波分析实现单相接地保护容易产生误判和漏判现象,采用暂态分量的大小和方向实现单相接地保护的方法需要准确计算暂态分量的频率和相位。
5)  spectrum of transients
故障暂态分量频谱差异
6)  temporary state quantity integrol
暂态量积分
补充资料:传导暂态和高频骚扰抗扰性试验


传导暂态和高频骚扰抗扰性试验
conducted transient and high frequency disturbance immunity tests

和冲击电流的输出能力。现行试验标准中规定的试脸波形有两组,第一组:开路电压1.2/50娜~短路电流8/20仁s,如图1(a)、(b)所示;第二组:开路电压10/700邵,如图1(c)所示,短路电流波形无规定。第一组适用于工业、民用所有低压设备的电派回路、工业用有可能遭受雷击的户外低压设备的控制和信号电路;第二组适用于与通信线路相连接的设备。┌────┬─┐ │一/ │ │ ├────┼─┼─────────────────────────────────────┐│茄 │ │___一___入 ││ ┌──┼─┼─────────────────────────────────────┤├─┼竭┐│} │ ,││ │亏││ │_T.一 │└─┼─┴┴─┼─────────────────────────────────────┘ │犷!… │ └────┘ 日口Ol┌─────┐ ├料──┐ │ │一/ │ │ ├───┼─┼────┐│._, │日│一孔竺一│├─┬─┼─┤ ││J │/ │ │ │└─┴─┴─┴────┘┌───┐ │BJ │ ├───┤ │万 │ ├───┼───┐│护 │、、 ││ ┌─┼───┤├─┤功│—T一 ││ │ │ │└─┼─┼───┘ │『│ └─┘ 一为如J-0众0.众认 图l浪涌抗扰性试验电压/电流波形(a)开路电压1.2/50衅;(b)短路电流8/20拜s; (e)开路电压10/700拌s 浪涌抗扰性试验的严酷等级如表1所示,表中数值适用于共模试验,差模试验数值减半。严酷等级应根据设备的安装条件选择。(见电滋扰扰性试脸) 快速暂态/脉冲群抗扰性试脸在有些产品标准中也简称为快速暂态干扰试验。试验目的是检验设备对极短暂态脉冲群的抗扰性。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条