1) steam blowing period
吹管周期
1.
During steam blowing process,steam blowing quality is being ensured,steam blowing period is being shortened and generating unit commissioning course is being quickened,through establishing effective measure of storing and draining water,engaging exhaustive work and optimizing.
在机组吹管过程中针对设备特点选择了合理的吹管工艺方式、吹管流程、吹管参数,在吹管实施过程中通过制定有效的储补水及排水措施、实施细致的准备工作以及吹管实施时进行优化运行控制等手段使得超临界压力机组吹管过程得以顺利实施,达到了保证吹管质量、缩短吹管周期及加快机组试运进程的目的。
2) soot blower period
吹灰周期
1.
The optimal soot blower occasion and the soot blower period were determined based on the accumulation degree of ash and slag on the heated surfaces of boiler,the sonic soot blower system was designed and the program was compiled.
根据锅炉受热面结渣和积灰程度,确定了各个受热面的最佳吹灰时机和吹灰周期,设计了声波吹灰系统,编制了运行程序。
3) blow cycle,blow mo(u)lding cycle
吹塑周期
4) blowing period
排污周期，吹灰周期
5) periodic blow-suction disturbance
周期性吹吸扰动
1.
The velocity time sequence at different vertical and longitudinal locations in a turbulent boundary layer with periodic blow-suction disturbance is finely measured by IFA-300 constant-temperature anemometer with resolution higher than the frequency that corresponds to Kolmogorov dissipative scale.
用IFA-300热线风速仪以高于对应最小湍流时间尺度的分辨率,精细测量了风洞中施加局部周期性吹吸扰动平板湍流边界层近壁区域不同法向和流向位置的瞬时速度的时间序列信号。
2.
In this paper, the technique of constant temperature anemometry, together with double-hot-wire-sensor probe, is used to carry out experimental study on the turbulent boundary layer, which is controlled by periodic blow-suction disturbance in the low turbulent level wind channel.
本文应用热线测速技术,对风洞中平板湍流边界层壁面施加周期性吹吸扰动进行了试验研究。
6) periodic blowing-suction
周期性吹吸气
补充资料：吹管分析(blow-pipeanalysis)
【吹管分析】(blow-pipeanalysis)定性分析法之一。将固体试样（有时另加试剂）放在木炭的凹穴中，用吹管吹火焰于被分析有试样上，借所呈现的现象如颜色、气味等，以鉴定某些元素或化合物的存在。通常用于矿物、无机物等的鉴定。设备简便，操作方便。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条