1) aspect ratio of loading area
加载面边长比
2) column aspect ratio
加载短柱边长比
3) loaded edge
加载边缘
4) side appending
边加载
1.
Design facts in side appending radial three-cavity transit time oscillator
边加载径向三腔渡越时间振荡器设计
5) side ratio
边长比
1.
On the basis of processing and analyzing the measured data of fluctuating pressure on rectangular rigid models with various side ratios and aspect ratios in a boundary layer wind tunnel, the effects of models height, aspect ratio, side ratio on the power spectra of torsional wind loads are studied.
针对矩形截面的高层建筑物,对不同高宽比和边长比的9种模型进行风洞实验,通过对大量数据的处理和分析,考察了模型高度、高宽比、边长比对高层建筑物扭转风向风力功率谱(扭矩功率谱)的影响规律,并拟合出了一个以风速、湍流强度、边长比等为参数的高层建筑物扭矩功率谱密度函数的数学表达式,与试验结果吻合较好,证明它是合理有效的。
6) Proportional loading
比例加载
1.
Multiaxial fatigue behavior of superalloy GH4169 was investigated by using the thin tubular multiaxial fatigue specimens under proportional and non-proportional loadings at high temperature.
高温多轴疲劳试验采用比例与非比例加载路径。
2.
Biaxial fatigue behaviors of the Zr-4 alloy under proportional and non-proportional loading with the phase angles of 30°, 60° and 90° were studied.
研究了冷变形Zr-4合金在双轴比例和非比例加载下的循环变形行为,结果表明:当循环应变幅较低时,Zr-4合金表现为循环初始硬化随后饱和的特征;随着应变幅提高,初期硬化后,表现为连续循环软化特征;高应变幅下,初期硬化消失,表现为急剧的循环软化。
3.
The deformation behavior of hydrided zircaloy-4 under tension-torsion proportional loading was investigated using the quantitative metallography and the finite element method(FEM).
采用有限元数值分析方法,模拟了含氢化物Zr-4合金拉-扭双轴比例加载下的变形行为。
补充资料：面长面短
1.指没有见过面的人的面庞形貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条