1) cyclic indentation
循环印压
1.
Objiective: To investigate the feasibility of assessing myocardial passive mechanical properties using ultrasound cyclic indentation and to lay foundation on assessing directly myocardial passive mechanical properties in vivo.
目的:探讨超声循环印压检测心肌被动力学属性可行性,为活体检测提供基础。
2) Cyclic Pressing
循环压制
1.
Spray formed large dimension 7075/SiCp composite was densified by cyclic pressing.
采用循环压制工艺对多层喷射沉积大尺寸7075/SiCp复合材料(高度H>140mm)进行了致密化加工。
2.
Large dimensional spray formed 7075/SiCp composite and extrusion billet were densified by cyclic pressing.
研究了多层喷射沉积大尺寸7075/SiCp复合材料的沉积坯和挤压坯两种坯料经过循环压制加工后SiC颗粒的分布,测试了复合材料循环压制后的力学性能,通过拉伸断口SEM形貌分析了复合材料的断裂行为。
3) circularly squash-milling
循环压研
1.
Technology of crushing RCA in a circularly squash-milling way;
RCA的循环压研破碎技术
4) recycled extrusion
循环挤压
1.
Research on Microstructure Properties of Aluminum Processed by Continuous Variable Cross-section Recycled Extrusion;
连续变断面循环挤压技术及纯铝变形组织性能研究
2.
Microstructure and properties of AZ31 magnesium alloy by continuous variable cross-section recycled extrusion
连续变断面循环挤压AZ31镁合金的组织与性能
3.
The metal flow behviors of Pb sample was studied in continuous variable cross-section recycled extrusion using grid measuring system.
采用铅试料,用网格法实验观测连续变断面循环挤压法挤压时金属的流动特征。
5) cyclic pressure dissipation
循环压耗
1.
Accurate calculation of cyclic pressure dissipation is the basis of programming of bit hydraulics optimization.
循环压耗的准确计算是钻头水力参数优化程序设计的基础。
6) circulating pressure
循环压力
1.
Theoretical calculations of circulating pressure of chilled water system in operating mode;
大厦冷冻水系统运行工况下循环压力的理论计算
补充资料：肺循环的驱动压
肺循环的驱动压
为肺血管内某一点与下游另一点的压力差。这压力差担负着驱动这两点间的血液流动和克服这段距离的摩擦阻力。总肺循环驱动压为肺循环起始部分(肺动脉）至肺循环终末(左心房）的压差。如正常人肺动脉平均压为1.9kPa(14mmHg），左心房压为0.66kPa(5mmHg），则肺循环总驱动压为1.9-0.66＝1.24kPa（14-5＝9mmHg）。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条