说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> pH静态试验
1)  pH-dependence test
pH静态试验
2)  static test
静态试验
1.
The results show that the toughness and displacement at peak load decrease with the fall of test temperature; the displacement at peak load of dynamic test is less than that of static test at the same temperat.
在不同试验温度下,对X70管线钢缺口沿厚度方向的标准夏比V型缺口试样进行动态试验和静态试验,研究了X70管线钢的力学性能与加载速率的关系。
2.
Then static test on the servo-valve has been done on the servovalve test-bed.
为进行液压流体脉动的主动消振,设计了基于压电陶瓷的直接驱动伺服阀,并利用AMESim液压仿真软件对其进行了建模与仿真,并在伺服阀实验台上对其进行了静态试验。
3.
In this case exit oil pressure remains constant, while in a turbine s static test the main oil pump, which supplies oil to the secondary and tertiary loop, has a variable exit pressure which is a function of the speed of rotation.
该文以上海汽轮机厂N1 2 35型汽轮机调速系统为例 ,探讨了用高压电动油泵进行静止试验的情况 ,由于其出口压力维持不变 ,静态试验时 ,供到二、三次油路的主油泵出口油压为一变数 ,系转速的函数 ,由此会产生差异 ,文中指出在同类机组进行调速系统试验时 ,此差异带来的误差很小 ,并推荐一种由静止试验和静态试验结果作四象限图的方法。
3)  static experiment
静态试验
1.
The optimum conditions of static experiment was obtained.
初步探讨了活性炭填充电极电解法处理苯酚废水的机理,对影响活性炭填充电极电解法处理苯酚废水去除率的各种要素,如反应时间、电流密度、原水浓度、pH值等进行了条件试验,得出了活性炭填充电极电解法去除苯酚静态试验的最佳试验条件。
2.
The characteristic of dielectric barrier discharge and its influencing factors were studied through static experiment,and chemical change about NO_x and carbon soot through non-thermal plasma were discussed.
根据低温等离子体的产生原理和柴油机有害排放物的生成特点,设计了结构和功能具有实用性的等离子体反应器;通过静态试验研究了介质阻挡放电的放电特性及其影响因素,探讨了低温等离子体的化学反应机理;通过柴油机台架试验对低温等离子体处理柴油机排气中的碳烟和NOx进行了研究。
3.
The results of the static experiment indicated that the CODCr removing rates of the test groups: "mixed culture + activated sludge", "mixed culture" and "activated sludge" were 91.
静态试验结果表明,"混合菌液+活性污泥"、"混合菌液"和"活性污泥"试验组的CODCr去除率分别为91。
4)  pH static state
静态pH
5)  still force hardness test
静态试验力
1.
The hardness test consist of the still force hardness test and the dynamic hardness test according the test force.
同时 ,按试验力状态 ,将这六个国家标准分为两种 ,静态试验力或动态试验力硬度试验方法。
6)  semistatic test
半静态试验
补充资料:静态试验
分子式:
CAS号:

性质: 相对动态试验而言,加于试样的负荷较小,形变速度足够缓慢或测定时间较短的强度试验。如拉伸试验,弯曲试验,硬度试验等。静态试验也可称为常规试验。不考虑材料的黏弹行为,不考虑应力-应变间的相位差,一般用经典的材料力学理论来处理问题。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条