说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 淤砂选矿
1)  concentration from silted deposition
淤砂选矿
2)  tailing after ore-dressing
选矿尾砂
3)  Silt [英][sɪlt]  [美][sɪlt]
淤砂
1.
Scandium Resources in Silt of Sanxia Reservoir and Its Utilization Possibility;
三峡库尾淤砂重庆段中钪资源及回收利用可行性研究
2.
The runway silt in the tail sector of the Three Gorges reservoir (the sector in Chongqing) contains scandium of 6.
长江三峡库尾 (重庆段 )淤砂含钪 6。
3.
The minerals of the silt of the end of Three Gorges reservoir of Yangtze River were studied.
对长江三峡库尾淤砂的矿物进行研究,通过光谱分析、化学成分分析、主要矿物含量测定,查明了其化学成分和矿物组成。
4)  deposited silt
淤砂
1.
The thick deposited silt, located on the river bed at the TGP s second stage cofferdam, could not be cleared up during the cofferdam construction.
三峡坝址河床覆盖层淤砂较厚,围堰工程施工设计又不能清除,针对堰基设计需要,对淤砂用作围堰基础的物理力学参数进行了试验研究和资料分析,提出了设计分析最不利情况的设计参数,以策安全。
2.
They mainly involve the seepage stability of the filling materials and deposited silt in its foundation, seepage situation analyses and evaluation with FEM to the cofferdam, and the seepage state and its influences on percolation stability of cofferdam under some possible disadvantageous operation conditions.
内容主要涉及围堰填料及堰基淤砂的渗透稳定性,围堰的渗流状态(有限元计算)分析及评价,不良工况下的渗流状态及对围堰渗透稳定的影响。
5)  Yangtze silt
长江淤砂
6)  silt accumulation
泥砂淤积
1.
The paper introduces in detail the selection of the main technical parameters of the intake unit, calculation of the intake unit dimensions, determination of the amount of silt accumulation and the methods of silt drainage, and so on.
在某给水改扩建工程的设计中,对取水构筑物的设计方案进行了比选,最终确定采用顺流式河岸内斗槽预沉(预沉渠道)取水方式,详述了该取水构筑物主要技术参数的选取、构筑物尺寸的计算、泥砂淤积量的确定及泥砂排除措施等,可为取水工程的设计提供参考。
补充资料:采砂船选矿


采砂船选矿
washing process on the dredge

e。一shoehuon xuon伙uong采砂船选矿(washlng proeess on the dredge) 在采砂船上利用重力选矿设备.把矿砂中的有用矿物分离和富集,并将砾石及尾砂排弃到采空区的工艺过程。通常在船上只获取粗精矿,然后将其送往岸上的精选厂或冶炼厂处理。在采砂船上进行重力选矿,要选择合适的选矿设备.要分清砂矿重选的难易等级,并选用合理的选矿工艺流程。 重力选矿设备主要有:用于进行碎散分级准备性作业的圆筒筛;用于选别作业的各种类型的溜槽、跳汰、摇床、.圆盘等选矿设备。可根据生产实际情况选用 砂矿重选的难易等级采用重力法分选砂矿的难易程度,主要决定于待选矿砂的密度差,用公式表示为: 了一艺 E一二尸一二 一了1一胜式中E为矿砂重选的难易程度指标;了:为有用矿物的密度;y、为脉石矿物的密度;艺。为介质的密度。按五值大小,可将矿砂的重选难易程度分为5个等级:E>2.5,较容易;E一2.5一1.7.容易;五一1.75一1.5.中等;艺一1·5一1·25,困难;E
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条