1) dense solid-gas flow
密相气固两相流
2) dense particle-gas two-phase
稠密气固两相流
1.
Activities of dense particle-gas two-phase flow modeling in Eulerian-Lagrangian approach;
稠密气固两相流欧拉-拉格朗日法的研究现状
3) Gas-Solid Two Phase Flow
气固两相流
1.
Concentration measurement of gas-solid two phase flow in the dipleg based on electrical capacitance tomography
基于电容成像的料腿内气固两相流浓度测量
2.
Tests on flow resistance characteristics of gas-solid two phase flow in pipes were performed on a 1:1 scale industrial pneumatic conveying system test rig.
在1∶1比例的工业气力输送系统试验台上,进行了输送管道中气固两相流的阻力特性试验,对影响气固两相流压力损失的主要因素,包括被输送物料的基本性质与特征,输送气体的物性,管道的特性和操作条件四个方面进行了分析与探讨,为气力输送系统的工程设计和理论研究提供了依据。
3.
The axial distributions of averaged solids holdup and the effects of operation conditions were investigated with the experimental data of pressure gradients of gas-solid two phase flow in a 16 m high CFB riser.
以 16m高循环床提升管中气固两相流压力梯度的大量实验数据为基础 ,从能量耗散的观点分析研究了平均颗粒浓度的轴向分布特征及其操作条件的影响 ,并与相同条件下 6m高提升管中颗粒浓度的轴向分布进行了对比。
4) gas-solid flow
气固两相流
1.
Advances of impact heat transfer between particles in gas-solid flow;
气固两相流中颗粒间碰撞传热进展
2.
To optimize the gas-solid flow field, numerical simulations were performed with a new raw meal inlet added to the SLC-S precalciner by changing the horizontal projection angle between the two raw meal inlets.
以SLC-S分解炉为基准模型,新增一个物料进口,分别对两物料进口在不同的相对位置时的气固两相流场进行了数值模拟。
3.
The realizable k-ε model and stochastic particle track model were used for gas-solid flow simulation.
采用可实现性k ε模型和随机颗粒轨道模型 ,对其气固两相流动进行了数值计算 ,得出了气相速度分布、颗粒浓度分布和流动阻力分布特性 。
5) gas-solid two-phase flow
气固两相流
1.
Flow distribution characteristics of gas-solid two-phase flows in a Y-shaped connection pipe;
Y型分支管道气固两相流动流量分配特性研究
2.
Recognition of Gas-solid Two-phase Flow Regime Based on LQV Neural Network;
基于学习矢量量化神经网络的气固两相流流型识别
3.
The theery and unmerical method for gas-solid two-phase flow in centrifugal fan s impeller;
离心风机叶轮内气固两相流动的理论及数值解法
6) gas-particle two-phase flow
气固两相流
1.
Numerical simulation of gas-particle two-phase flow in the primary air channel of direct-flow pulverized coal burner;
直流燃烧器一次风通道气固两相流数值模拟
2.
Experimental study of gas-particle two-phase flow in the primary air channel of direct-flow pulverized coal burner
直流燃烧器一次风通道气固两相流实验研究
3.
Based on Eulerian treatment of gas phase,Eulerian treatment of particle continuum and momentum equations,as well as Lagrangian treatment of particle energy and mass transport equations,a three-dimensional mathematical model of turbulent gas-particle two-phase flow and pulverized coal combustion is formulated in the raceway of blast furnace.
基于欧拉气相方程组、欧拉颗粒连续方程和动量方程以及拉氏颗粒能量和质量变化方程,建立并发展了高炉风口回旋区湍流气固两相流动和煤粉燃烧的三维数学模型。
补充资料：密相流化床
分子式：
CAS号：
性质： 几乎所有的流化床都属密相流化床。密相液体流化床内固体颗粒是均匀分散的，所以亦称均一流化床或平稳流化床。密相气体流化床内有明显的鼓泡现象，床层由气泡相（亦称泡晕相）和乳浊相组成。气泡相内固体颗粒很少，只有在尾涡区含有几乎与乳浊相相同的颗粒，乳浊相内的固体颗粒密度很高，通常接近于最小流化速度时的密度。
CAS号：
性质： 几乎所有的流化床都属密相流化床。密相液体流化床内固体颗粒是均匀分散的，所以亦称均一流化床或平稳流化床。密相气体流化床内有明显的鼓泡现象，床层由气泡相（亦称泡晕相）和乳浊相组成。气泡相内固体颗粒很少，只有在尾涡区含有几乎与乳浊相相同的颗粒，乳浊相内的固体颗粒密度很高，通常接近于最小流化速度时的密度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条