说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 冷凝强度
1)  condensadon_intensity
冷凝强度
2)  enhanced condenser tube
强化冷凝管
1.
In this paper, according to the special requirements of the submarine air-conditioning water-chiller unit, the discussion and choice of the enhanced condenser tube have been made, and the experimental study of the heat transfer performance has been conducted.
根据潜用空调冷水机组用强化冷凝管的特殊要求,对强化冷凝传热管进行了讨论选择,并对其传热 性能进行了实验研究,最后对潜用空调冷水机组冷凝器的传热性能进行了实验研究与分析。
3)  condensation temperature
冷凝温度
1.
The condensation temperature and evaporation temperature are variational in condensator and evaporator using R22/R142b non-azeotropic mixture refrigerant.
R2 2 /R14 2b非共沸混合制冷剂在冷凝器和蒸发器中其冷凝温度和蒸发温度是变化的。
2.
Through a theoretical analysis the authors have derived a relationship for calculating the mean condensation temperature of a multi-pressure condenser, which has taken into account the variation of heat transfer factor with the change of condenser construction scheme and cooling water inlet temperature.
通过理论分析 ,得出考虑传热系数随凝汽器结构和冷却水入口温度变化条件下多背压凝汽器的平均冷凝温度的关系式 ,分析了各级传热面积和循环倍率对平均冷凝温度的影响 ,并以多背压凝汽器的平均冷凝温度为目标函数 ,得出多背压凝汽器的最优结
3.
,air wet-bulb temperature,condensation temperature and relative moisture were conducted.
对影响板式蒸发式冷凝器热工性能的主要因素——空气的湿球温度、冷凝温度、相对湿度做了实验研究。
4)  condensing temperature
冷凝温度
1.
Discussion of the condensing temperature in the standard of SCREW REFRIGERANT COMPRESSORS;
《螺杆式制冷剂压缩机》标准中冷凝温度的探讨
2.
Some researches in an ice harvester machine are made which indicate that the evaporating temperature is the most significant factor which influence the COP (Coefficient of Performance) of a refrigeration compressor while both the evaporating temperature and the condensing temperature are two main factors.
通过对某冰片滑落式冰蓄冷空调系统运行的分析及研究,表明在影响制冷机COP值的两大因素——蒸发温度和冷凝温度中,蒸发温度占主导地位,要提高制冷机运行的COP值应当首先考虑提高制冷机的蒸发温度。
3.
By use of such refrigerants,the compressor discharging temperature is almost equal to the condensing temperature,and problems relative to high compressor discharging temperature are avoided.
可使工质在压缩过程中始终接近饱和蒸气状态,压缩机排气温度约等于工质的冷凝温度,从而可较好地解决排气温度过热所引起的一系列问题。
5)  condensing rate
冷凝速度
6)  heavy condensation
高度冷凝
补充资料:表光合强度(见光合强度)


表光合强度(见光合强度)
forecast of sowing or transplanting time

b iaoguanghe qiangdu表光合强度见光合强度
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条