1) Cu-Zn-Cr-Zr alloy
Cu-Zn-Cr-Zr合金
2) Cu-Cr-Zr alloy
Cu-Cr-Zr合金
1.
Erosion wear behavior of Cu-Cr-Zr alloy in liquid-solid two-phase flow;
液固两相介质流中Cu-Cr-Zr合金的冲蚀磨损行为
2.
Electrical sliding wear behavior of Cu-Cr-Zr alloy;
Cu-Cr-Zr合金电滑动磨损行为研究
3.
Effects of Ageing and Deformation on Properties of the Cu-Cr-Zr Alloy;
时效与形变对Cu-Cr-Zr合金性能的影响
3) Cr-Zr-Cu alloy
Cr-Zr-Cu合金
1.
The variations of microstructure of Cr-Zr-Cu alloy before and after deep cryogenic treatment(DCT) were observed and analyzed by means of optical microscope,TEM,XRD and so on.
通过研究发现,深冷处理使Cr,Zr粒子弥散析出,能使Cr-Zr-Cu合金出现孪晶结构,并且长时间的深冷处理使铜合金的XRD衍射峰值的强弱发生明显的变化,即深冷处理使铜合金晶粒发生了转动,出现了择优取向。
4) Cu-Zn-Cr alloy
Cu-Zn-Cr合金
1.
The effects of different heat-treatment process on Cu-Zn-Cr alloy s hardness are studied.
文章通过不同的热处理工艺来研究固溶时效对Cu-Zn-Cr合金硬度的影响。
2.
Cu-Zn-Cr alloy was prepared by Ingot Metallurgy.
发现，Cu-Zn-Cr合金的强化机制包括固溶强化、形变强化及析出强化。
3.
The results show that: The first,Cu-Zn-Cr alloy is .
Cu-Zn-Cr合金是典型的时效强化型合金。
5) CuZnAl based alloy
Cu-Zn-Al-Zr合金
6) Al-Zn-Mg-Cu-Zr alloy
Al-Zn-Mg-Cu-Zr合金
1.
Effect of Sc on as-cast microstructures and mechanical properties of Al-Zn-Mg-Cu-Zr alloys;
Sc对Al-Zn-Mg-Cu-Zr合金铸态组织和力学性能的影响
2.
Effects of electromagnetic casting on as-cast microstructures and solid solubility inside crystals of Al-Zn-Mg-Cu-Zr alloy
电磁铸造对Al-Zn-Mg-Cu-Zr合金微观组织及晶内固溶度的影响
3.
Optimum retrogression and reaging heat treatment of super-high strength Al-Zn-Mg-Cu-Zr alloy containing Sc
含Sc超高强Al-Zn-Mg-Cu-Zr合金的回归再时效处理制度
补充资料：cu、zn-superoxide dismutase
CAS: 9054-89-1
中文名称: 过氧化物岐化酶
英文名称: Dismutase, superoxide；cu、zn-superoxide dismutase；superoxide dismutase；Dismutase,superoxide
中文名称: 过氧化物岐化酶
英文名称: Dismutase, superoxide；cu、zn-superoxide dismutase；superoxide dismutase；Dismutase,superoxide
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条