1) firmware design
固件设计
1.
0 control system interface circuit,describes the three components of USB application system software design:firmware design,the development of drive procedure,user interface communication procedure,designs and realizes the interface control circuit of USB2.
0控制系统接口电路硬件原理及其软件实现方式,叙述了USB应用系统软件设计的三部分:固件设计、驱动程序开发、用户接口通信程序,设计并实现了基于CPLD的USB2。
2.
This paper presents the performance of EZUSB chip,and offers the implementation of drive program development,firmware design and application program communication.
介绍了EZUSBFX2芯片性能,给出了驱动程序开发、固件设计和应用程序通信的实现方法。
3.
This paper introduced the system\'s hardware schematics and the humiture data acquisition methods,and a more detailed analysis of wireless communication protocol and USB firmware design method.
对系统的硬件原理及温湿度采集方法进行了介绍,对无线通信协议及USB固件设计方法进行了较详细分析。
4) Consolidation design
加固设计
1.
Based on the stability zone classification,different consolidation designs are carried out.
根据不同分区的稳定状态采取了不同的加固设计方案,节省了地灾治理经费。
2.
Through the introduction of the design option of Tangjia Bridge Road (S) under-railway tunnel the paper points out the importance of drainage and consolidation design of tunnels in coastal area.
通过介绍汤家桥南路下穿铁路的地道设计方案,指出在沿海地区地道排水及加固设计的重要性。
5) Reinforcement design
加固设计
1.
The application of complex support form in reinforcement design of side slope;
复合支护形式在边坡加固设计中的应用
2.
Researches on the stability calculation and reinforcement design of the continuous welded rails with small radius curves;
小半径曲线无缝线路稳定性计算及加固设计
3.
Reinforcement Design and Study on Small Curvature Radius Curced Continuous Girder Bridge Under Over Loading;
重载作用下小半径连续弯梁桥加固设计与研究
补充资料：1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
叠 135Omm双流板坯连铸机(重庆钢铁设计研究院设计)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条