1) the peak compress stress
压应力峰值
2) peak stress
峰值应力
1.
In order to research on correlative functions of peak stress and deformation stored energy with Zener-Hollomon parameter,the elevated temperature tensile test of 45 steel was carried out at Gleeble-1500D thermal-mechanical simulator,in the range of deformation temperature 1123-1273K and initial strain rate 0.
01~5s-1,并采用双曲正弦模型,研究了45钢在高温拉伸条件下的峰值应力、变形储能与Zener-Hollomon参数的关系函数。
2.
The model of thermal deformation and the relationship of peak stress,peak strain and Z were obtained that provide basic data for prediction and control of microstructure and properties of tested steel products.
975 kJ/mol,并建立了试验钢动态再结晶热变形模型和峰值应力、峰值应变与Z因子的关系,为预报和控制该钢的组织和性能提供了基本依据。
3.
The activation energy of deformation was calculated and the relationship among peak stress and deformation temperature and strain rate was established.
实测了高温下应力-应变关系曲线,观察了变形后的显微组织,计算了材料的激活能,并建立了峰值应力与变形温度和应变速率的关系。
3) peak stress
应力峰值
1.
One method to decrease the peak stress at the joint of nozzle and thick cylinder was introduced in this article.
本文介绍了一种降低厚壁圆筒与接管连接处应力峰值的方法。
4) peak pressure
峰值压力
1.
Influence of length/diameter ratio of explosive charge on in-tunnel blast peak pressure;
装药长径比对坑道中冲击波峰值压力影响的试验
2.
The results indicate that: the cavity radius becomes stable at approximately 6000μs;the blasting pressure waves mainly are transmitted horizontally;the peak pressure has a negative logarithm relationship with distance perpendicular to the charging bisector;and the valid influence area r.
应用ANSYS/LS-DYNA有限元程序对条形装药黄土地基中爆炸过程进行了三维数值模拟,发现在6000μs爆炸空腔已基本稳定,条形装药爆炸产生的压力波以水平方向传播为主,装药中垂线方向爆炸产生的峰值压力与离中垂线距离呈负对数关系,土的有效影响范围半径大约为爆炸后形成的空腔半径的4倍。
3.
The experimental results show that the peak pressure and positive pressure actuation duration by the first drilled explosion on the same measuring points are less th.
试验结果表明:在相同试验条件下,相同测点处一次钻孔爆炸所产生的峰值压力和正压作用时间要小于二次钻孔爆炸,其衰减速度要低于二次钻孔爆炸,但其衰减趋势均符合岩石介质中压力波衰减规律。
5) pressure peak value
压力峰值
1.
The paper pointed out that a gas density, fire location and energy are the important factors to the size and display time of the explosion pressure peak value.
指出瓦斯浓度、火源位置及能量是决定爆炸波压力峰值大小及显示时间重要因
6) pressure peak
压力峰值
1.
This paper is to realize the characteristics and transmitting rules of underwater drilling blasting shock wave through studying the test data and pressure undulance acquired from small test of underwater drilling blasting in shore,considering the effect of depth to the pressure peak value of shock wave.
文章对近岸海底浅水中钻孔爆破小型试验取得的试验数据及压力波形进行研究,初探水深因素对水底钻孔爆破水中冲击波压力峰值的影响。
2.
The results show that the sympathetic explosion of detonator(depends) on both the shock pressure peak and its duration,and the shock pressure peak is the chief factor.
实验得出,雷管在密实介质中受冲击波作用殉爆与否取决于冲击波压力峰值及峰值持续时间的大小,并认为冲击波压力峰值是决定雷管殉爆与否的首要因素,当冲击波压力峰值达1。
3.
The conclusion shows that the elastic deformation of stored material and its speed do good to breaking discharing arch and reducing pressure peak.
结果表明：贮料及仓壁的弹性变形及其传播有助于破拱和削弱压力峰值，从而为全面分析筒仓的工作提供了一定的理论计算依
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条