1) thick film LEC
厚膜LEC
2) heavy layer
厚层;厚膜
3) film thickness
膜厚
1.
Analyze composition and film thickness of multilayer alloy film sample by using online method of basic parameter;
使用在线基本参数法对多层合金薄膜样品的成分和膜厚同时定量分析已成为现实
2.
The relationship between the organism removal, reaction rate parameter and film thickness in biological aerated filter;
曝气生物滤池去除有机物与反应常数及膜厚的关系
3.
According to the characteristics and demands of inspecting the required amount of printing plate lubrication in modern printing industry, a new method was put forward to measure the direct dynamic film thickness of printing plate fountain solution.
针对现代印刷生产过程中润版液供给量检测的特点和要求,提出了1种新的利用光纤及其传感技术,实现对润版液膜厚的直接动态测量的方法,并分析了其检测原理,给出了检测系统的结构组成。
4) thick film
厚膜
1.
Preparation and characterization of PZT thick film for piezoelectric cantilever beam by sol-gel;
用于压电悬臂梁的PZT厚膜的溶胶-凝胶制备及表征
2.
Fabrication and investigation of Si-based PZT thick films;
硅基高度择优取向PZT厚膜的制备及性能研究
3.
Study on Integrated Capacitive Pressure Sensor of Thick Film;
电容式压力传感器的厚膜集成化研究
5) Membrane thickness
膜厚
1.
Modeling and control of ceramic membrane thickness during dip-coating process;
浸浆制备过程中陶瓷膜厚度控制及其模型化
2.
Effects of microstructure of supports and technological controllers of film coating on ceramic membrane thickness during dip-coating process;
浸浆制备过程中载体微结构及涂膜工艺参数对膜厚度的影响
3.
A simple model of dynamic membrane forming in crossflow filtration is presented which can predict filtrate flux and dynamic membrane thickness through the analysis of force on the particles.
通过对错流过滤系统中悬浮颗粒的受力分析,建立动态膜涂膜过程数学模型,可计算整个过程中的膜通量和膜厚度。
6) Scale thickness
膜厚
1.
The variation of scale thickness ofthe steels with resp.
结果显示,在试验条件下,3种材料腐蚀产物膜的断面形貌显示出双层结构,表层是晶体规整的 结晶状态,表层与基体之间为类似泥浆状的固体薄层;3种材料在模拟采出液中腐蚀产物膜的厚 度和晶粒大小随着温度的变化情形大致相似,在120℃时均达到了最大,而极小值并不相同;膜 厚和晶粒大小的极大值或极小值所对应的温度3种材料均相同;3种材料的腐蚀产物膜厚度或表 面晶粒大小随CO2分压变化规律大致相近,在CO2分压为6。
2.
The effect of pressure on scale thickness and grain size is investigated by using scanning electron microscope (SEM).
结果表明 ,在试验条件下 ,3种钢的腐蚀产物膜均为双层结构 ;膜厚随CO2 分压变化情况比较相近 ,在CO2 分压为 6 90MPa时均达到最大 ,在超临界压力以上急剧减小 ;表面晶粒尺寸随CO2 分压变化出现 2峰 1谷 ,在超临界压力以上急剧减小。
3.
The effects of temperature on the scale thickness of corrosion product and crystal average grain size of the corrosion products were analyzed using the scanning electron microscope.
结果显示 ,3种材料所得到的腐蚀产物膜的纵向形貌为双层结构 ;其膜厚随着温度变化的最大值均在 12 0℃处 ,N 80和J5 5两种钢的最小值在 160℃处 ,而P110钢则在 180℃处。
补充资料：厚礁膜
 | |
| 俗名: | 厚礁膜 |
| 产地及产期: 生长在中潮带岩石上。生长盛期4～6月。产于嵊山。可供食用。 | |
| 介绍: 藻体黄绿色，有光泽，片状，膜质，单层细胞，高3～6厘米。从藻体边缘深裂至基部的裂片数个，裂片边缘多皱褶，并有短小的片状突起。藻体边缘厚36微米左右，近基部厚85～90微米。 |
|
| ©2011 dictall.com | |