1) Wide common-mode range input stage
宽共模范围输入级
2) wide input common-mode range
宽输入共模电压范围
1.
In order to meet the demand for a wide input common-mode range (ICMR) required by high-side current-sensing amplifiers,input stages whose ICMR can exceed the supply rail were researched and analyzed.
针对高端电流检测放大器输入级对宽输入共模电压范围的要求,对宽输入共模电压范围放大器的输入结构开展了研究,提出了一种宽共模输入范围的输入级结构,特点是具有低输入偏置电流,并能兼顾高低共模电平工作的需要。
3) wide common-mode input range
宽共模输入电压范围
1.
A new hysteresis-current control circuit was proposed,which uses a comparator with wide common-mode input range(CMIR) and effectively weakens the effect of input bias current on the sampling current,because the current-sensing signal is input from the base of bipolar transistor.
提出了一种新型滞环电流控制电路,其采用宽共模输入电压范围的比较器结构,电流检测信号从双极型晶体管基极输入,能有效减小对检测电流的影响。
4) ICMR
共模输入范围
1.
High GBW amplifier with large input common-mode range(ICMR) is introduced to enhance differential-mode range of input signals.
密勒电容反馈的引入,使等效保持电容大大增加,从而有效地抑制了模拟开关的电荷注入效应带来的采样误差;设计大共模输入范围的高增益带宽积的放大器,以提高信号差模输入范围和精度;采用由分频器组成的准采样电路,避免了保持输出信号的抖动对后级电路(如ADC的比较器)的影响。
5) high CMR
高共模输入范围
1.
In this paper, a input stage that workes with low power supply and high CMR and approximately constant gain in the whole CMR for CMOS OPAMP is studied.
为了达到高共模输入范围 ,我们采用了 N/P互补差分对 。
6) wide input range
宽输入范围
1.
A Gilbert cell multiplier with wide input range has been designed based on TSMC 0.
设计了一种基于CMOS工艺设计的宽输入范围的Gilbert单元乘法器。
补充资料：共模干扰与串模干扰
共模干扰与串模干扰
common-mode interfer-ence and differen-tial-mode interfer-ence
gongmo ganroo yu Chuonmo gonroo共模千扰与串模干扰(eommon一mede inter-ference and differential一mede interferenee)见电力系统调度信息。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条