1) VLS technique
气-液-固工艺
2) vapor-solid process
气固工艺
3) process of liquid-solid extruding
液-固挤压工艺
4) solid/liquid separation with flotation/sedimentation
新型气浮-沉淀固液分离工艺
5) curing process
固化工艺
1.
The technoloies progress about organic passivation,roll coater and curing process of chromate-free organic passivation for galvanizing sheet steel were summarized.
概述了国内外镀锌钢板有机无铬钝化技术涉及的有机钝化剂、涂覆与固化工艺研究的进展。
2.
The curing process of KH- 304 resin matrix composites is studied in this paper.
本文研究了ＫＨ—３０４树脂基复合材料的固化工艺，指出加压点必须选在树脂粘度最低之前。
3.
The curing processes were analyzed and the XRD and microstructure of the composites were analyzed.
67μm范围的钛酸钡(BaTiO3)作为高介电填充组分,采用溶液共混合旋涂工艺,制备了不同BaTiO3含量的0-3型BaTiO3/环氧复合材料膜,研究分析了环氧树脂固化工艺的确定以及不同BaTiO3含量的复合材料的晶相及显微结构。
6) curing technology
固化工艺
1.
Influence research of curing technology by orthogonal test on mechanical properties of carbon fiber reinforced composite;
固化工艺对碳纤维增强复合材料力学性能影响的正交试验研究
2.
The curing technology of the TDE-85/MeTHPA resin modified by polyurethane was discussed by DSC curve and IR atlases.
采用该预聚体、扩链剂、交联剂对TDE-85/甲基四氢邻苯二甲酸酐(MeTHPA)树脂体系进行改性,通过红外光谱和示差扫描量热法(DSC)分析,探讨与确定了聚氨酯改性环氧树脂体系固化工艺条件。
3.
The effect of these facters on bonding strength had been tested to obtain the best curing technology parameters of the adhesive with low viscosity for building to the desirable bonding quality,meeting with the project problems.
对影响建筑结构胶粘接强度的各工艺参数进行了试验研究,确定了低粘度结构胶最佳固化工艺参数,并结合工程施工提出相应解决措施。
补充资料：采气工艺(见天然气开采工艺)
采气工艺(见天然气开采工艺)
gas production technology
，一‘J\匕乙吕天然气开采工艺pro以uetionteehnology)见
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条