1) Phase changed network with switch
开关和差网络
1.
Considering the system s special requirement, a Phase changed network with switch is designed with power divider and microwave switch.
根据系统特殊的需要,利用微波开关和功率分配器、功率合成器,设计出了开关和差网络。
2) sum-difference network
和差网络
1.
A cross shaped sum-difference network is constituted by microstrip ramose coupler with compact structure and calculated by ADS,while the 8×8 rectangular patchs,which is optimized by HFSS on basis of the method of parameter load and so on,form the transmiting/receiving antenna.
采用新型平面微带型和差网络实现了Ku波段单脉冲天线阵列的小型化设计。
3) sum-and-difference network
和差网络
1.
A compact planar ultra-broadband sum-and-difference network;
一种小型超宽带平面和差网络
4) sum and difference network
和差网络
1.
In order to realize the miniaturization of the monopulse antenna feed network,reduce loss and improve the consistency of each port,a Ka-band sum and difference network of waveguide type is designed in this paper.
为了实现单脉冲天线馈电网络的小型化,降低网络损耗,提高各端口一致性,本文在波导耦合电桥的基础上,设计了Ka波段波导型平面和差网络,分析了网络各端口幅度和相位不一致对单脉冲天线波束的影响。
5) Switch network
开关网络
1.
After finishing the development flows including general purpose TUA ports design, UUT test points-instruments matching, switch network design and TUA engineering design, a general purpose TUA can be worked out automatically.
建立了一整套通用适配器自动设计流程,在依次完成通用端口设计、UUT测点资源匹配、适配器开关网络设计、相关工程设计后即可实现自动设计一个通用适配器的目的。
2.
Each cluster consists of a numberofsub-clusters which areconnected by a switch network.
分析了综合化航空电子核心处理系统的需求,设计了综合化航电核心处理系统IAPS——分布式计算机体系结构,IAPS采用双余度FC光纤网络连接多个机群,每个机群是由多个子机群通过开关网络互连组成。
3.
Through analyzing the power flow in a switch network,a calculation method and formula and its program block diagram of conductance ratio of every switch are put forward in this paper.
通过对开关网络的潮流分析,得出实际运行条件下计算开关网络中各开关电导比的公式和求解方法,并给出了程序框图。
6) switching network
开关网络
1.
Logic modeling and algorithm of relay secondary circuit based on switching network;
基于开关网络的继电保护二次回路逻辑的模型与算法
2.
This paper presented a method to get the minimum connection matrix from a generalized switching network.
给出了一种提取广义开关网络中两节点间“最小”连接矩阵的方法。
补充资料：《网络分析和反馈放大器设计》
论述网络分析和反馈放大器设计的名著，H.W.博德著，1945年在美国出版。作者在本书中叙述并发展了网络的一般理论，首先提出在一个网络中任何元件的回归差F 等于该元件具有正常值时的网络行列式与该元件值为零时网络行列式之比,推导出回归比T和环路传输μβ的关系
F＝1+T＝1-μβ
详细推导了网络函数的实部和虚部之间的关系，并把这种关系应用于负反馈放大器的输入、输出和级间网络的设计上。
详细推导了网络函数的实部和虚部之间的关系，并把这种关系应用于负反馈放大器的输入、输出和级间网络的设计上。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条