1) Pull to stretch the burthen two times
二次拉伸负荷
2) full load stretching
满负荷拉伸
1.
In the end,formula of stretching force that real plate stretching requires lower load stretching between full load and lower load stretching is confirmed,and influence of equipment cost about minimum width of plate in full load stretching is confirmed.
确定了在满负荷和降负荷拉伸之间,实际板材拉伸需要降负荷拉伸的拉伸力公式,以及满负荷拉伸最小板材宽度对设备成本的影响。
3) twice drawing
二次拉伸
1.
Adopting once punching process and using fewer cost and worse plasticity leftover material finish twice drawing of compound die.
分析了小圆角圆筒件的成形工艺性,利用成本较低、塑性较差的角料,采用一次冲压工序完成二次拉伸的复合模。
4) secondary load
二次负荷
1.
Secondary voltage-fall and secondary load affect power-measure accuracy;
二次压降和二次负荷对电能计量准确度的影响
2.
The design of online-test instrument for secondary load of transformer based on DSP;
基于DSP的互感器二次负荷在线测试仪的研制
5) secondary burden
二次负荷
1.
It is analysed in this paper that the tesing methods for real secondary burden of instrument transformers,the secondary burden of instrument transformers could be tested accurately,thus the measurement could be more accuracy.
分析了互感器实际二次负荷的测量方法,使互感器的二次负荷能够被准确测量,从而使计量更加准确。
2.
The paper also presents drawing method of relation curve of accuracy limit factor and secondary burden.
分析了电流互感器复合误差所涉及到的各个方面,从应用层面说明了互感器对复合误差的要求,进而介绍复合误差的直接测量法和间接测量法,文中提到的两种方法都是实用、易行的,并且叙述了电流互感器准确限值系数与二次负荷关系曲线的绘制方法,另外还列举出实例进行说明。
6) succeeding stretch roller
二次拉伸辊
补充资料：输出反馈(见线性二次型次优控制)
输出反馈(见线性二次型次优控制)
output feedback
3h日c卜口fon以以{输出反馈型次优控制。(output王eedbaek)见线性二次
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条