说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> r射线复合处理
1)  60Co r-ray
r射线复合处理
2)  Complex treatment
复合处理
1.
Thus the effect of the complex treatment of the coating by the organic silicon sol was investigated, based on a comparative study of the performance of the Zn-Cr coatings before and after the complex treatment using neutral salt-fog corrosion test, sulfur dioxide corrosion test, acidic medium corrosion test, flowing water spraying erosion test, and measurement of the coat.
为了进一步探索改善锌铬膜涂层性能的途径,扩大锌铬膜涂层的应用范围,采用有机硅溶胶材料对锌铬膜涂层复合处理,并进行性能测试。
2.
By this complex treatment combining ion\|nitriding with subsequent ion plating, surface hardened layer is composed of TiN and nitrided layer.
通过离子氮碳共渗与离子镀硬质膜复合处理在低合金钢基体表面上形成较厚的强化层,可使表面硬度达到2200HV0-1 以上。
3.
The laser quenching and ion sulphidizing complex treatment technology were operated on the cylinder wall surface of high power disel engine to decrease the wear of both ring and cylinder and increase the service life for cylinder.
采用扫描电子显微镜、能谱仪、X射线衍射仪、显微硬度计等分析设备对缸套内壁的强化层进行表征分析,采用T11高温摩擦磨损试验机对处理前后缸套内壁的抗高温磨损性能进行了比较研究,研究结果表明:缸套内壁经过激光渗硫复合处理后,抗高温粘着性能大大提高,同时渗硫层能够防止发动机刚启动时机油润滑不良导致的异常磨损和改善摩擦副之间的润滑效果。
3)  duplex treatment
复合处理
1.
Tribological behaviors of SCM415 low alloy steel by duplex treatment;
低合金钢渗镀复合处理层的摩擦学性能
2.
In this paper,we will research on the structure,appearance,microhardness and corrosion resistance of duplex treatment layer of the sample,which is carried out duplex treatment to the Q235 steel by using the associative technique of gas multi-component permeation and acid chemical plating.
研究了Q235钢经气体多元共渗加化学镀复合处理后,试样表面复合处理层的结构与形貌、显微硬度和抗盐雾腐蚀特性。
3.
The formation of “black layer” in the duplex treatment of nitriding and vapor deposition of TiN film has been investigated from the points of thermo-dynamics and kinetics.
通过对渗氮层中连续化合物层 (“白亮层”)的稳定性与气相沉积工艺特性的分析 ,从热力学和动力学两方面分析了渗氮-气相沉积TiN复合处理时“黑色层”的形成机理。
4)  composite treatment
复合处理
1.
Composite Treatment of Concasting Mold Flux for Ultra-Low-Carbon Steel;
超低碳钢连铸结晶器用保护渣的超细复合处理
2.
The paper first introduces some traditional surface treatments on the saucers in the edible oil saucer separator and puts forward the nitriding-laser quenching composite treatment.
介绍了食用油碟式分离机碟片的常规表面处理方法,提出了渗氮激光相变硬化复合处理技术,通过硬度实验、耐磨性实验、抗腐蚀性实验及残余应力分布曲线,对实验结果进行了较深入的分析,得出渗氮激光相变硬化复合处理技术可提高4C r13钢碟片抗腐蚀能力和抗疲劳性能的结论。
3.
To treat soft soil foundation,Two and more method which is called soft soil foundation composite treatment is adopted.
采用两种或两种以上方法联合处理软土地基,一般称为软土地基的复合处理。
5)  combined treatment
复合处理
1.
Mutagenic effects of the combined treatments with ~(60)Co-γ ray and HNO_2 on the peppers;
γ射线和亚硝酸复合处理对辣椒的诱变效应
2.
Surface combined treatment of carbonitriding and B-C-N-RE multi-elements deep-penetrating on 20Cr steel firebrick die
碳氮共渗-深层稀土硼碳氮共渗复合处理在20Cr钢耐火砖模具中的应用
3.
A combined treatment with ion nitriding & ion sulfurizing was carried out on the surface of grey cast iron.
对灰铸铁进行离子渗氮渗硫复合处理,采用SEM、EDAX和XRD研究了渗层的组织结构,采用往复式滑动磨损试验机及SRV型高温摩擦磨损试验机分别在无润滑和油润滑条件下,对原始材料、离子渗氮表面、离子渗氮渗硫复合处理表面进行了摩擦学性能研究,并探讨了磨损机理。
6)  Compound treating
复合处理
1.
This paper deals with the structure property of 40 Cr steel treated by ion nitrocarburizing and compound treating,the atmosphere was prepared with NH3 and 1% C3H8 mixture.
采用氨气和丙酮作气源研究了40Cr钢离子碳氮共渗和复合处理后组织性能。
补充资料:抗X射线辐射复合材料


抗X射线辐射复合材料
anti-X-ray composite materials

  抗x射线辐射复合材料anti一X一ray compositematerials用于抵抗X射线辐射造成对材料结构的破坏效应的一类复合材料。材料吸收系数是衡量光子和材料作用的能力。它取决于光子能量和材料所含元素的性质。一般讲元素的原子序数越大,吸收系数越大。X射线照射到材料上,则光子与材料的原子发生作用,X射线在物质中迁移时,被物质吸收变成物质的内能,即X射线能量在物质中沉积。同时,X射线能流密度大,释放的时间极短,使材料的比内能急剧增加而升高温度,并且在材料表面处形成很高的压力。结果在材料表面形成一个峰值极高、持续时间极短的压力脉冲一热击波,使材料产生“层裂”效应,同时产生瞬时过载,结构产生变形,乃至破坏。 为了防止X射线的破坏作用,曾提出一种物理模型。它由迎光层、屏蔽层、衰减层和过渡层4层结构组成。衰减层采用泡沫塑料,其他层分别采用碳一酚醛、高硅氧一酚醛等复合材料。利用密度小、质量轻的硅酸盐类多孔复合材料,既可防止大能量的X射线的辐照,同时也是解决能量沉积行为的极好材料。 (于翘)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条