1) maximum allowed transfer time
最大传输时间
2) Minimal Transmitting Time
最小传输时间
3) maximum transmitting time delay
最大传输延时
4) transmission time
传输时间
1.
Measuring method and system for sonar signal transmission time;
声呐信号传输时间测量方法与系统
2.
Analysis in effects to high frequency protection command transmission time in carrier wave channel;
浅析高频保护命令载波通道传输时间的影响
3.
This paper introduces the parameter testing methods of protection channel,including transmission time,time broadening and removing locked signal etc.
文章简要介绍了有关保护通道的几种重要参数的测试方法,这些测试包括对传输时间、展宽时间、解除闭锁信号的测试等,简单介绍了测试电路的原理。
5) travel time
传输时间
1.
A Scheduling Problem with Travel Time Between Machines;
考虑工件传输时间的一类排序问题
2.
The flowshop scheduling problem with travel time between machines is very practical and useful in the Robotics and FMS.
考虑传输时间的同顺序排序问题是在机器人设计及柔性制造系统中有着广泛应用的一类排序问题。
6) time transfer
时间传输
1.
The micro-wave time transfer system between Lintong and Pucheng has been used to synchronize the time signal from the time-keeping clock room(located in Lintong)and the signal from the broadcast control clock room(located in Pucheng)for over 28 years till the end of 2006.
中国科学院国家授时中心的临潼--蒲城微波时间传输系统承担着守时基准钟房(临潼)与发播控制钟房(蒲城)之间的时间同步比对任务。
2.
This paper developed a new approach to improve GPS carrier phase measurement, for the purpose to reduce the ambiguity integer value or use it in time transfer technology.
并用这种理论应用在载波相位测量的改进上,以降低模糊度确定的复杂性,或用于时间传输技术。
补充资料:最大功率传输定理
最大功率传输定理 maximum power tramsfer,theorem on 关于负载与电源相匹配时,负载能获得最大功率的定理。对于交流传输电路,负载与电源匹配是指负载阻抗等于电源内阻抗的共轭复数时的电路工作状态。负载与电源匹配是负载获得最大功率的条件。但在此条件下,电路的传输效率仅为50%。对于弱电系统(如雷达、射电望远镜、电子仪器等)这是允许的,因为这些系统总是希望负载尽可能得到最大功率。但对于强电系统,例如电力系统则不允许,因为这类系统中重要的目标是求得最大的效率,而不是最大功率,在强电系统中绝不允许50%的功率不产生任何效益地消耗掉。 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条