说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> [军]爆破(式)战斗部
1)  blast warhead
[军]爆破(式)战斗部
2)  demolition warhead
爆破式战斗部
1.
Aiming at the damage characteristic of demolition warhead,a new mode of fuze-warhead coordination that missile detonates with the mode of proximity burst while flying over target,and contact explosion in other state of missile and target encountering,was put forward.
针对空地反辐射导弹爆破式战斗部的毁伤特性,提出了一种导弹飞过目标近炸,其它弹目交会情况触发起爆的新的引战配合方式。
3)  blast fragmentation warhead
杀伤爆破战斗部
4)  Fragmentation warhead
破片式战斗部
1.
In this paper,the background of double focuses fragmentation warhead is introduced,the mathematic model for double focuses warhead is established.
介绍了双聚焦破片式战斗部研制背景和特点,建立了双聚焦破片式战斗部的数学模型,根据传统的设计方法进行了计算机辅助设计研究,给出了聚焦式战斗部具体的仿真方法和优化设计方法。
2.
The killing probability of fragmentation warhead of missile to air target and its influence factors were analyzed.
以某拦截弹破片式战斗部杀伤战术弹道导弹为例进行了仿真计算,并对仿真结果进行了分析,结果表明增大战斗部破片的杀伤半径对提高战斗部的杀伤概率有利。
3.
Based on these, models for calculating the damage done by a fragmentation warhead upon the target can be built up.
在此基础上建立了破片式战斗部对地面复杂目标的毁伤计算模型 ,并以装甲输送车为例进行了计
5)  fragmentation artillery warhead
破片式战斗部
1.
An evaluating approach for the vulnerability of the lightweight armored vehicle to attack by fragmentation artillery warhead;
破片式战斗部对轻型装甲车辆的易损性分析方法及计算模型
2.
The fragmentation artillery warhead is utilized in the paper.
本文采用战斗部为破片式战斗部,通过对导弹发射车的易损性分析,目标毁伤树来建立目标易损性计算模型。
6)  blast-fragmentation warhead
杀爆战斗部
1.
The damage models of overpressure and fragments,the lethality models of blast-fragmentation warhead,and the model of missile target encounter are established.
文中从地面飞机毁伤特性分析入手,结合杀爆战斗部特点和起爆策略,构建了目标超压和破片毁伤模型、战斗部超压和破片威力模型、弹目交会模型等,在典型条件下对地面飞机进行了毁伤仿真计算,为导弹作战运用研究和毁伤效果评估提供了一种切实可行的技术途径。
2.
The engineering calculation method for the lethal probability of the blast-fragmentation warhead exploding in the air was introduced.
分析了破片场空间分布规律,介绍了一种空爆型杀爆战斗部杀伤概率的工程计算方法。
3.
Based on the flying and distributing character of the fragments,a model of the lethality of blast-fragmentation warhead was built.
文中通过分析破片的飞行特性及空间分布规律,建立了杀爆战斗部杀伤威力计算模型,并对某预制破片战斗部进行了计算,得出了破片场的破片密度及杀伤概率分布规律,得到了不同落角情况下杀伤面积随爆高的变化曲线,并确定了不同落角情况下的最佳爆高值。
补充资料:串联式空习装药战斗部
[英文]:series shaped-charge warhead
[解释]: 反坦克导弹、反坦克火箭和发射的反坦克破甲弹,一 般都采用空心装药战斗部。这种战斗部装药的端有一个圆锥形空腔,紧贴着药覆盖一个金属药型罩。空习装药 可使爆炸产生的能量聚集在对准目标的方向,同时使融化的药型罩形成一股金属射流向前方射出,把装甲击穿 。空习装药战斗部的破甲厚度通常可达药型罩锥口直径的3~5倍,所以装药的直径越大,存甲厚度越大。一般 的破甲弹只有一个空习装药战斗部。为了对付外持反作用装甲的坦克,把两个空心装药战斗部串联起来,前面一 个较小的装药先起爆,炸毁反作用装甲,然后主装药起爆,空透主装甲。这就是串联式空心装药战斗部。这两个 装药的轴线必须严格在一条直线上,破甲的效果才会更好。目前已有不少新型反坦克导弹和反坦克火箭弹采用 串联式空心装药战斗部,例如俄罗斯的AT-7反坦克导弹和 RPG-27、RPG-29反坦克火箭弹,美国的“陶”-2A反坦克导弹 ,法国和德国联合研制的“霍特”-2T、“米兰”-2T反坦克导弹,瑞典的“比尔”-2反坦克导弹和以色列的ZT-35 反坦克导弹待。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条