1) laminating temperature
层压温度
2) strata temperature and pressure
地层温度与压力
3) Paving Temperature
碾压层的摊铺温度
4) formation temperature
地层温度
1.
Study on method of real time predicting formation temperature while drilling;
实时随钻预测地层温度方法研究
2.
The formation temperature controls the physiological activity of the microbe and the production of the methane.
分析了地层温度、咸化环境和还原环境等因素对阳信洼陷沙一段生物气生成、聚集和保存的控制作用。
3.
The distributions of flowing parameters in well bore at different formation temperature and varying tubing-head pressure were discussed.
阐述了不同地层温度与井口压力下井筒气体流动参数的分布 ,并说明了不同地层温度下 ,井口回压对井底流压与产量的影响。
5) interpass temperature
层间温度
1.
Preheat and interpass temperature were determined,the welding material was choosen,the relevant process parameters,the welding procedure and the heat-treatment procedure were worked-out.
研究了T91与10CrMo910钢的异质焊接工艺,确定出预热和层间温度,选择了焊接材料,制订出相应的工艺参数和焊接、热处理工艺。
2.
The influence of welding heat input and interpass temperature on the impact value of the welded joint -30℃temperature are analyzed.
分别就焊接线能量、层间温度变化对焊接接头的-30℃冲击韧性的影响进行了试验,并用光学显微镜和电子显微镜观察了接头组织。
3.
In this paper,it adopts process actions,such as preheating,controlling heat input and interpass temperature,post-heat and slow cooling and it makes use of relative detecting method to impect the guality in low temperature welding.
通过采取焊前预热、控制焊接线能量和层间温度、焊后保温缓冷等工艺措施,并采用相应的检测方法,保证了胺液吸收塔的低温焊接质量。
6) interlayer temperature
层间温度
1.
According to the test,the welding interlayer temperature of X60 pipeline in the normal and low temperature is analyzed in order to study the influence of its variable range on welding quality.
针对涩北至格尔木天然气管道复线建设中采用的X60管线钢,根据试验,分析了常温与低温焊接时层间温度变化对管口焊接质量的影响,并指出了防止涩格天然气管道焊接产生冷裂纹的工艺措施。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条