说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 充液管
1)  filling pipe,filling line
充液管
2)  fluid filled pipe
充液管道
1.
Through the review of current research in energy flow,the correlation equations of affecting and restricting energy flow are analyzed on the basis of energy flow definition,the reasons of vibrating of the fluid filled pipe are discussed,the methods are explored,and the developing trend on energy flow is predicted.
通过综述、归纳能量流的研究现状,从能量流的定义中分析影响和制约能量流的相关因数,说明了充液管道振动的原因,探讨了能量流的研究方法,指出了能量流研究的发展趋势。
2.
This paper first explains the reasons of vibration in fluid filled pipe system.
阐述了充液管道系统振动产生的原因,并用频率—波数分析结构的振动以及消减充液管道振动的主动控制技术和被动控制技术,指出了充液管道系统振动控制具有良好的研究及应用前景。
3.
The dispersion equation of structure acoustic coupling system for fluid filled pipes surrounded by elastic media under axisymmetric motion was derived from shell dynamic equation.
从壳体基本运动方程出发 ,导出了弹性介质中的充液管道在轴对称运动下声振耦合系统的频散方程 。
3)  liquid-filled elbow pipe
充液弯管
1.
Modal frequency calculation for liquid-filled elbow pipe;
充液弯管的模态频率计算
4)  liquid-filled piping system
充液管系
5)  pipe system conveying fluid
充液管路
1.
Flexural vibration property of periodic pipe system conveying fluid based on Timoshenko beam equation
基于Timoshenko梁模型的周期充液管路弯曲振动带隙特性和传输特性
6)  fluid-filled circular tube
充液圆管
补充资料:降液管液柱高度
分子式:
CAS号:

性质:又称降液管清液层高度。板式塔降液管内的液柱液面到下层塔板的垂直距离。如图中的Hd(图暂缺)。为保持板式塔正常操作,避免发生液泛,降液管液柱高度不能超过一定限度。一般应满足Hd≤(0.4~0.6)(HT+hw),式中HT为塔板间距,hw为堰高,系数一般取0.5,易起泡物系取0.4,不易起泡物系取0.6。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条