1) partial suspension of solids
固体部分悬浮
2) suspended solid
悬浮固体
1.
Additionally, electric dehydration, oil cut of waste water and suspended solid content were also tested.
考察了辅助剂、破乳剂和聚合物的浓度、温度、矿化度、pH值、剪切强度和其它药剂等对破乳剂与辅助剂构成的复合破乳性能的影响和电脱水试验,测定了污水含油率和悬浮固体含量。
2.
Suspended solid in the Water will affect the normal growth of submerged plants, in turn, submerged plants will affect the concentration of suspended solid and it's settlement in the water.
水中悬浮固体会影响沉水植物正常的生长,沉水植物反过来也会影响水中悬浮固体的浓度和沉降。
3.
In response to the problems existing in internal recycle three-phase fluidized bed,a high-efficient separation biological fluidized reactor (BFR) was designed by coupling the internal recycle fluidized bed with high-efficient dissolved air floatation,and the removal effect on suspended solid was investigated.
针对内循环三相生物流化床存在的问题,设计出了内循环流化床与溶气气浮相耦合的高效分离生物流化复合反应器(BFR),并考察了其对悬浮固体的去除效果。
4) suspended solids
悬浮固体
1.
Determining suspended solids content,SS,in polymer containing oilfield produced water(OFPW) by using the membrane filtration method(MFM) recommended in P R of China s oil/gas Trade Standard SY/T 5329-94 always leads to a prolonged filtration time and abnormal,rather high SS values.
采用石油天然气行业标准推荐的膜滤法测油田含聚采出水中悬浮固体含量时,过滤时间长而测定值偏高。
2.
95% of suspended solids ranging from 30.
05μm的悬浮固体,可截留92。
6) suspended solid
固体悬浮物
1.
Laboratory simulation of resuspension of suspended solids in Changdou Harbor of Taihu Lake;
太湖长兜港固体悬浮物再悬浮的室内模拟
2.
When amount of compounded flocculant PC was 100 mg/L,the content of suspended solid was 4.
研制了一种适合于聚合物驱后含油污水处理的复配絮凝剂PC,其主要由改性聚合氯化铝PAC、新型阳离子聚合物CPM和破乳剂L-64复配,经筛选确定其最佳复配比例为m(CPM):m(PAC):m(L-64)=7:12:1,当絮凝剂PC加药浓度为100 mg／L时,固体悬浮物含量可降至4。
补充资料：混合液挥发性悬浮固体
分子式：
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体在灼烧温度为550℃时的分馏物。它表明可用于生物氧化时的活性微生物的浓度。MLVSS一般可按MLSS的70％估计。
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体在灼烧温度为550℃时的分馏物。它表明可用于生物氧化时的活性微生物的浓度。MLVSS一般可按MLSS的70％估计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条