1) photoluminescence
[,fəutəu,lju:mi'nesns]
光致发光<光>
2) Photoluminescence
[,fəutəu,lju:mi'nesns]
光致发光
1.
Synthesis and properties of the photoluminescence material containing rare earth Nd and polyurethane;
稀土钕/聚氨酯光致发光材料的合成与性能研究
2.
A study on preparation and photoluminescence property of SiO_2 xerogel;
SiO_2干凝胶的制备与光致发光性能研究
3.
Study on the morphology and photoluminescence of porous silicon doped with cerium;
铈掺杂多孔硅的形貌和光致发光研究
3) Photoluminescence(PL)
光致发光
1.
The effects of annealing temperatures on properties of the films were investigated by X-ray diffraction(XRD),photoluminescence(PL) and optical transmittance and four-probe method.
离子注入后,样品在500~900℃氮气气氛中退火,利用X射线衍射(XRD)、光致发光(PL)、透射谱和四探针研究了退火温度对薄膜性能的影响。
2.
The photoluminescence(PL) properties of the three groups samples are investigated,which are influenced by anodizing voltage,anodizing time and electrolyte concentration respectively.
用电化学阳极氧化工艺,在草酸电解液中制备了3个系列的多孔阳极氧化铝(AAO)薄膜样品,分别考察了氧化电压、氧化时间以及电解液浓度对样品光致发光的影响。
4) luminescence
[英][,lu:mɪ'nesns] [美]['lumə'nɛsṇs]
光致发光
1.
Synthesis and luminescence properties of Eu(Ⅲ) complex with 1,10-phenanthroline and salicylic acid;
铕(Ⅲ)三元配合物的合成与光致发光性能
2.
Preparation and Luminescence Property of Layer-by-layer Self-assembled Nanometer Multilayer Film Based on Polyoxometalate and Tris(2,2-bipyridine)ruthenium;
多金属氧酸盐-三(2,2′-联吡啶)钌层接层自组装纳米复合膜的制备及光致发光性质
3.
Luminescence of Eu￣(2+) and Mn￣(2+) and Their Energy Transfer in SrMgP_2O_7;
Eu~（2＋）和Mn~（2＋）在SrMgP_2O_7中的光致发光及其能量传递
5) PL
光致发光
1.
Study on PL Properties of β-Diketone with ICT Function and Their Metallic Complexes;
具有ICT性质的β-二酮及其金属有机配合物的光致发光性质研究
2.
The Cu doped TiO_2 nanoparticles were prepared by a sol — hydrothermal process,and also were characterized by XRD,SPS and PL.
采用溶胶-水热法合成掺杂Cu的TiO2纳米粒子,利用XRD,SPS和PL等测试手段对样品进行了表征,重点研究了Cu掺杂对样品表面光电(SPV)和光致发光(PL)性质的影响,并探讨了Cu的作用机制。
3.
Meanwhile, comparison of the PL spectrum between the derivative and C60, the derivative has increased PL phenomena at 450 nm at the room temperature.
对其光致发光光谱的特性进行研究，并与Ｃ６０发光光谱比较，室温下观测到峰值位于４５０ｎｍ附近较强的光致发光现象。
6) photoluminescence (PL)
光致发光
1.
The microstructure and photoluminescence of these films were systematically studied by measurements of micro-Raman, photoluminescence (PL) and high resolution transmission microscope (HRTEM).
实验研究了退火前后薄膜样品的结晶状态和光致发光特性。
2.
Xray diffraction (XRD) and photoluminescence (PL) spectra were used to characterize the structural and optical properties of the thin films.
X射线衍射谱的结果表明:未经热氧化样品由金属锌和氧化锌纳米晶组成,随着热氧化温度的升高氧化锌纳米晶粒长大,形成纳米氧化锌多晶薄膜且薄膜结晶性增强;光致发光谱表明:样品均具有较强的紫外自由激子发光。
3.
The photoluminescence (PL) spectra are found to have 4 luminescent band peak at 320nm,410nm,560nm,and 630nm,respectively,at room temperature.
利用双离子束溅射沉积共溅射方法制备了富Si SiO2 薄膜 ,研究了沉积参数、时间、工作气压PAr、基片温度等对沉积速率的影响 ,用TEM和XRD分析了样品的结构 ,当基片温度Ts <4 50℃时 ,所制备一系列样品均为非晶结构 ,当沉积基片温度较高时 (Ts ≥4 50℃ ) ,薄膜样品中才出现Si的颗粒 我们还分析了样品的室温光致发光现象 ,从PL谱中可以看出 ,样品有～ 32 0nm、～ 4 10nm、～ 560nm和～ 630nm四个PL峰 ,并对其发光机理进行初步探
补充资料：场致发光材料(见电致发光材料)
场致发光材料(见电致发光材料)
electroluminescent material
见场致发光材料eleetrolumineseent material 电致发光材料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条