1) forced-path testing
![点击朗读](/dictall/images/read.gif)
强制性路径测试
2) path testing
![点击朗读](/dictall/images/read.gif)
路径测试
1.
On Program Testability Based on Path Testing;
![点击朗读](/dictall/images/read.gif)
基于路径测试的程序可测试性研究
2.
This paper focuses on automatic test data generation for path testing using genetic alg.
![点击朗读](/dictall/images/read.gif)
本文主要研究的是路径测试数据的自动生成方法。
3.
This paper focuses on automatic test data generation for path testing using genetic algorithms.
本文主要对面向软件测试中路径测试的数据自动生成方法进行研究。
3) path coverage test
![点击朗读](/dictall/images/read.gif)
路径测试
1.
In accordance with the characteristics of path coverage test and the graph theory,this paper presents a new program control flow diagram model.
针对路径测试的特点,结合图论的知识,提出了控制流程图的一种表示方法。
2.
In accordance with the characteristics and coverage requirement of path coverage test as well as the graph theory,this paper presents a new program control flow diagram model.
针对路径测试的要求及其特点,结合图论的概念,提出了程序控制流程图的一种表示方法。
4) test path
![点击朗读](/dictall/images/read.gif)
测试路径
1.
The test paths of an example to satisfy each testing criteria are listed in a table.
![点击朗读](/dictall/images/read.gif)
然后通过例子,给出了基于各个标准产生的测试路径,最后给出了结论以及下一步应考虑的问题。
2.
Focusing on the problem of infinite paths created by the events for GUI,the author presented a test path generation approach for GUI based on event weight in an event-flow graph(EFG).
针对GUI事件驱动特性产生无限多个测试路径的问题,提出在事件流图中考虑事件权重的GUI测试路径生成方法。
5) path test
![点击朗读](/dictall/images/read.gif)
路径测试
1.
Study on Automatic Generating Path Test Data Based on PSO;
![点击朗读](/dictall/images/read.gif)
基于PSO的路径测试数据自动生成方法研究
6) Z-path test
![点击朗读](/dictall/images/read.gif)
Z路径测试
补充资料:测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条