说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 燃料储存稳定性
1)  fuel storage stability
燃料储存稳定性
2)  shelf stability
储存稳定性[粘合剂、糊料]
3)  storage stability
储存稳定性
1.
Preparation of modified bituminous emulsion and its storage stability;
乳化改性沥青的研制及其储存稳定性
2.
Effect of hydrophilic colloids on storage stability and sensory quality of defatted yoghurt;
亲水胶体对脱脂发酵乳储存稳定性和感官品质的影响
3.
Effect of stabilizer to the storage stability of modified asphalt emulsion;
稳定剂对乳化改性沥青储存稳定性的影响
4)  storage stability
存储稳定性
1.
Morphology of disperse phase droplets of the new type emulsified base with high-content metal ions (Fe3+and Mn2+) was observed by SEM and the storage stability and the thermal stability of the bases were investigated.
并对其存储稳定性和热稳定性进行了初步研究。
2.
The present test "Polymers Modified Asphalt Separation Test" can not reasonably reflect the change process of the storage stability.
采用动力剪切流变试验方法,测定复数模量和相位角,给出评价改性沥青存储稳定性的指标———离析率的计算公式。
3.
With regard to the shortcomings of present storage stability test, a new instrument was developed and was used in studying the storage stability ofSBS modified asphalt.
针对现行规范测试方法的不足,开发了新的改性沥青存储稳定性测试仪,并利用两种方法对SBS改性沥青的存储稳定性能进行了研究。
5)  hot storage stability
热储存稳定性
1.
Sampling method and evaluation factor for investigating the hot storage stability of SBS polymer modified asphalt;
SBS聚合物改性沥青热储存稳定性取样方法和评价指标
2.
Study of hot storage stability of SBS chemically modified asphalt;
反应性SBS改性沥青热储存稳定性研究
3.
In this paper hot storage stability of SBS, SBS-g-MAH Modified asphalt system was studied by DSC.
用示差扫描量热仪 (DSC)从能量变化的角度研究 SBS、SBS- g- MAH改性沥青的热储存稳定性 ,同时借助 FT- IR、软化点对改性沥青体系进一步分析研究。
6)  charge storage stability
电荷储存稳定性
1.
Effect of ultraviolet radiation on electret charge storage stability;
紫外消毒对驻极体电荷储存稳定性的影响
2.
The results show that the charge storage stability of film electret increases remarkably in high humidity surroundings after chemical surface modification.
采用补偿法对六甲基二硅胺烷 (hexamethyedisilane ,HMDS)和二氯二甲基硅烷 (dichlorodimethsiliane ,DCDMS)化学表面修正恒压电晕充电硅基氮化硅 (Si3N4)薄膜驻极体及氮化硅 /二氧化硅 (Si3N4/SiO2 )薄膜驻极体的电荷储存稳定性进行了比较性的研究 。
3.
By controlling the process of sol gel, the charge storage stability of porous silica thin film electret based on silicon substrate were investigated by measurements of IR spectra, isothermal surface potential decay and current spectra of open circuit Thermally Stimulated Discharge (TSD).
实验结果表明 ,反应物中水含量对薄膜驻极体的电荷储存稳定性及陷阱分布有一定的影响 ;烧结温度和时间对电荷的储存稳定性的影响较
补充资料:乏燃料储存


乏燃料储存
storage of spent fuel

  (参见彩图擂页第30页46图)②利用地下岩洞建造的储存水池,瑞典的CLAB装置即属此类。该装t由乏燃料接收、储存及辅助厂房三部分组成。唯储存水池建在岩洞中.岩洞长120m,宽Zlm,高27m,由整块岩石分割的四个水池组成。岩洞有防止外部冲击的良好性能,在内部意外事故下也可隔离环境,从而使环境免受污染。 储存格架有不含中子吸收材料和含中子吸收材料的两种.前者利用乏燃料间的距离来控制临界;后者将中子吸收材料制成方形孔道并依次焊在一起,底部与厚钥板底座相连。底座上开孔,以便水通过孔道冷却乏徽料(见图)。 由于乏嫩料带有强放射性和余热,对储存水池的设计及其运行必须遵循以下要求:①抗展:地展等自然灾害能直接破坏水池,或因格架、起重机等掉人而损坏水池,故储存水池应按一级抗展要求设计;②核设计:在乏燃料最大储存容量下确保将其布置得处于次临界状态,为此,在设计中假定燃料是未经过辐照的和水池充满纯水,此时格架及转运装t形成的增殖系统的有效增殖系数k.ff不超过0.90;③热工水力设计:水池冷却系统必须考虑在正常运行条件下,当水池存满乏嫩料时.水他的最高温度不燃料组件┌─┬─┬─┬─────┬───┬─┬───┬──┐│{ │1 │) │二二】 │「二」│…│.二工 │东弃││…│ │ │巨一一一一│ │ │ ├──┤│ │ │ │ │ │ │ │…\ ││ │ │ │ │ │ │ ├──┤│ │ │ │ │ │ │ │.r │├─┼─┴─┴─────┴───┴─┴───┴──┤│王│少 ││ │ 、二 ││ ├──────────────────────┘└─┘ 储存水池底储存格架简图超过50℃;④其他:如对起重机操作、防护水层高度和水位监测、避免乏燃料损伤等都有一定的要求。 千式储存世界各国已建成的干式储存设施主要有空气冷却储存室、干式混凝土容器、干井及金属容器四种。 空气冷却储存室将乏燃料储存在重混凝土屏蔽的空气冷却储存室,空气通过自然对流将乏燃料的衰变热带走,由烟囱排出。储存室内分隔成若干圆柱形孔道,带有外包装容器的乏嫌料组件垂直存放在孔道内。乏燃料组件的间距应保证不发生临界。储存室可设t在地面,也可在地下。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条