1) two-column friction screw press
双柱式摩擦压力机
2) double friction-gear press
双盘摩擦压力机
1.
Measurement and impororement of force and energy parameters for a 300-ton double friction-gear press;
300t双盘摩擦压力机力能参数测定及其改进
3) Friction press
摩擦压力机
1.
Die forging mold design of half-round supporting wheel 1600t friction press;
1600t摩擦压力机上支重轮半体模锻成形模具设计
2.
In this paper,after the traditional forging preocss of the cylinder of the hydraulic pump was analyzed,a new extrusion technology on 400t friction press was proposed.
文章对液压泵转子的成形工艺进行分析,提出在400t摩擦压力机上镦挤成形,同时时设计出一套适用性较强的组合模具,进行批生产。
4) friction screw press
摩擦压力机
1.
S7-200-based and energy controllable CNC system for the friction screw press;
基于S7-200可能量预选的摩擦压力机数控系统
5) double disc friction screw press
双圆盘摩擦压力机
6) Vincent friction screw press
上移式摩擦压力机
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条